Post a picture... any picture
Options
Comments
-
That is a gorgeous 800B.
Gorgeous.
The service manual shouldn't be too hard to find, and it will (should) include instructions on restringing the dial cord. Antique Electronic Supply at least used to have dial cord; Radio Daze probably does if AES doesn't.
Yes, it is well worth rehabbing those for a multitude of reasons, but that one looks to have had an easy life. The output tubes look amazingly 'young' based on the condition of the getter flash on all four of 'em). The Fisher receivers are extremely well engineered and (IMO) quite easy to refresh compared to some other, less thoughtfully laid out components from their era.
Here's an under-deck photo of a Fisher 400 (the entry level, FM-only model, a bit newer than the "B" series) which I refreshed; illustrating (IMO) how nicely laid out these things are.
undersidenoveau by Mark Hardy, on Flickr
-
PS The Fisher push-pull 7868 and push-pull 7591A receivers (i.e., 400, 500B/C and 800B/C) all sound very, very good, too! FM sections are quite nice sounding as well. Phono sections are OK.
-
mhardy6647 wrote: »That is a gorgeous 800B.
Gorgeous.
The service manual shouldn't be too hard to find, and it will (should) include instructions on restringing the dial cord. Antique Electronic Supply at least used to have dial cord; Radio Daze probably does if AES doesn't.
Yes, it is well worth rehabbing those for a multitude of reasons, but that one looks to have had an easy life. The output tubes look amazingly 'young' based on the condition of the getter flash on all four of 'em). The Fisher receivers are extremely well engineered and (IMO) quite easy to refresh compared to some other, less thoughtfully laid out components from their era.
Here's an under-deck photo of a Fisher 400 (the entry level, FM-only model, a bit newer than the "B" series) which I refreshed; illustrating (IMO) how nicely laid out these things are.undersidenoveau by Mark Hardy, on Flickr
Thank you for your nice comments and quick eval. I'll be sure to keep you posted on
any progress. These are indeed well built and heavy. When stuff was made to last.
-
The AM section should be pretty good in it, too! I don't own an 800, so I actually don't know
-
If those knobs are like the Fisher 400 then (maybe) the knobs have caps on the ends that fall of due to old glue. Easy pop on with a dab of glue.There was a place on Ebay that sells them.Randy-Maine
2ch-RTA15tl crossover upgrade
by David WMG
Yamaha cr1000 cr2040
HT-Yamaha Parasound Acurus
MIT BJC Cs1000p Polk Rotation -
1st ones I saw BTWRandy-Maine
2ch-RTA15tl crossover upgrade
by David WMG
Yamaha cr1000 cr2040
HT-Yamaha Parasound Acurus
MIT BJC Cs1000p Polk Rotation -
Thanks for answering that question, @boston1450!
The caps aren't too hard to find -- and I think there are modern reproductions available, as well. Maybe that is one
-
in other news -- the second half of October does not usher in the nice part of autumn in [Northern] New England.
-
We have had low/mid 20's over here. Hope to see a ole fashion New England winter this year. Love November in NE. Wouldnt mind a 15ft snowfall this winter
Randy-Maine
2ch-RTA15tl crossover upgrade
by David WMG
Yamaha cr1000 cr2040
HT-Yamaha Parasound Acurus
MIT BJC Cs1000p Polk Rotation -
mhardy6647 wrote: »in other news -- the second half of October does not usher in the nice part of autumn in [Northern] New England.
Have you and your neighbors decorated your yards, road sides, mailboxes... for Halloween again this year? Always enjoyed the photos you shared.
-
Yes, although we didn't put one up this year
We do have a good plan for next year, though.
I've only photographed one -- there are some good ones, though (there always are).
I think I posted a photo of the one in the center of our village, didn't I?
Here's the "official" site.
https://www.pumpkinpeople.org/2019-pumpkin-people-photos/ -
It is not ugly in Baltimore this morning
-
-
It is not ugly in Baltimore this morning
That campus looks so much prettier than it did when I was there.
Note: correlation is not causation!
-
Seen on Facebook.
https://www.audubon.org/magazine/summer-2019/the-2019-audubon-photography-awards-winners
Post edited by aprazer402 on -
it's all in the nose.... -
aprazer402 wrote: »
Soon even ice cubes will have that same steam effect up here. Not looking forward to that! -
Digging out the wintah clothes.
Randy-Maine
2ch-RTA15tl crossover upgrade
by David WMG
Yamaha cr1000 cr2040
HT-Yamaha Parasound Acurus
MIT BJC Cs1000p Polk Rotation -
^^^ I can play too!
-
12 deg F and blowing 35 mph at work. YukGustard X26 Pro DAC
Belles 21A Pre Upgraded with Mundorf Supremes
B&K M200 Sonata monoblocks refreshed and upgraded
Polk SDA 1C's modded / 1000Va Dreadnaught
Wireworld Silver Eclipse IC's and speaker cables
Harman Kardon T65C w/Grado Gold. (Don't laugh. It sounds great!)
There is about a 5% genetic difference between apes and men …but that difference is the difference between throwing your own poo when you are annoyed …and Einstein, Shakespeare and Miss January. by Dr. Sardonicus -
12 deg F and blowing 35 mph at work. Yuk
Makes the rig wiggle a bit up on top. I've set down lights on the arm of a few cranes over the years. Good times! -
oh, and might I just add... if I were to endeavor to say the words rig wiggle several times in succession... my head would 'splode just like those Martians' noggins in that movie Mars Attacks. -
Those strips are KOOLRandy-Maine
2ch-RTA15tl crossover upgrade
by David WMG
Yamaha cr1000 cr2040
HT-Yamaha Parasound Acurus
MIT BJC Cs1000p Polk Rotation -
^^^^ Now I have just GOT to have a Tabby Ironing Board® for Christmas!
-
Ya, the stupid contractors never want to do it when it's on the ground before assembly. Then they want someone like you to install them 350 ft in the air...Gustard X26 Pro DAC
Belles 21A Pre Upgraded with Mundorf Supremes
B&K M200 Sonata monoblocks refreshed and upgraded
Polk SDA 1C's modded / 1000Va Dreadnaught
Wireworld Silver Eclipse IC's and speaker cables
Harman Kardon T65C w/Grado Gold. (Don't laugh. It sounds great!)
There is about a 5% genetic difference between apes and men …but that difference is the difference between throwing your own poo when you are annoyed …and Einstein, Shakespeare and Miss January. by Dr. Sardonicus -
Ya, the stupid contractors never want to do it when it's on the ground before assembly. Then they want someone like you to install them 350 ft in the air...
Piece of cake.
It took me the whole 10 hour day to set and wire them
If you catch my drift. -
Not to change the subject, but I saw this Someplace Else and thought it amusing enough to share. I'm funny that way.
You know how there's this cottage industry of "clones" of famous and/or expensive amplifiers now being made in a large Asian country and sold for pennies on the dollar relative to their inpirations? (and that aren't really clones at all in any meaningful sense of the word?)...
Well, I saw photos of one posted today someplace else* that I found amusing. This particular clone has gotten even less clone like, apparently, by now adding "VU meters". Interestingly, they do appear to be bona fide VU meters...
... they've got the Dolby NR calibration point marked on 'em and everything.
Just like your favorite 1970s cassette decks.
Jeepers.
___________________
* https://audiokarma.org/forums/index.php?threads/1969-hood-amp-repro.794345/page-8#post-13182202
-
Didn't used to happen this bad before I lowered my car. Only an inch.
afterburnt wrote: »They didn't speak a word of English, they were from South Carolina.
Village Idiot of Club Polk -
-
