Billet RD-0194/8 tweeter plate design.
Options
Comments
-
Rob has been a busy boy.Political Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."
President of Club Polk -
Another beautiful anodization job. Also looking forward to your CRS+ install impressions.
Don't take experimental gene therapies from known eugenicists. -
Where did my picture go?
Where's your install pics? Got to build another 1-piece X-over plate to match tweeters and the red anodized is popular.Don't take experimental gene therapies from known eugenicists. -
Let me see what I have, if not I will take some new pics, I have the 1.2's pulled from the system at the moment.
I personally think the red looks the best, I have tried other colors, and they just looked horrible on a speaker, red or black is where it's at IMO.. -
Flash
No flash
Political Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."
President of Club Polk -
Damn, they exist.Don't take experimental gene therapies from known eugenicists.
-
Last tidbit detail. I machined the coil lead channels to accommodate any common 1/2" wide electrical tape.(White tape used as reference) Simply snip 1.25" lengths for each side and place over wire lead while slightly overlapping silk dome fabric.....
Bump for those asking about the swap procedure...
Don't take experimental gene therapies from known eugenicists.