Post a picture... any picture

Options
1…354355357359360…1153

Comments

  • CH46E
    CH46E Posts: 3,595
    Options
    How in the heck did they get them all to stand there long enough?
    Nice pic!
    · Share on Facebook
  • Lostsoul123
    Lostsoul123 Posts: 28
    edited November 2019
    Options
    He's to the right of the great dane on the left right behind the... Oh face it! He's horizonally challenged!
    All tube designed Hello Kitty boom box
    Invisible aluminum wireless Phazer speaker wire
    Free Spirit Teleport Preamp (Literally brings the artists into your living room)
    1.44 JW Flux Capacitor Mono Amps
    · Share on Facebook
  • collector
    collector Posts: 19
    Options
    CH46E wrote: »
    How in the heck did they get them all to stand there long enough?
    Nice pic!

    Somebody was holding a plate of steaks. :p
    · Share on Facebook
  • mhardy6647
    mhardy6647 Posts: 35,510
    Options
    85zn7urqz0l0.jpg

    fricken winter wonderland here.


    · Share on Facebook
  • Willow
    Willow Posts: 11,339
    Options
    Snow is almost all gone here.
    · Share on Facebook
  • mhardy6647
    mhardy6647 Posts: 35,510
    Options
    we had a wintry mix yesterday :p
    It should be mostly gone by tomorrow.
    · Share on Facebook
  • mhardy6647
    mhardy6647 Posts: 35,510
    Options
    8wigh0y3gcqj.png

    source: https://www.americanradiohistory.com/Archive-Audio/70s/Audio-1973-06.pdf
    · Share on Facebook
  • pitdogg2
    pitdogg2 Posts: 27,766
    Options
    HE HAD HAIR .... :D:D:D

    Sexy little devil
    · Share on Facebook
  • pitdogg2
    pitdogg2 Posts: 27,766
    edited November 2019
    Options
    Clipdat wrote: »
    Thought this was a pretty badass looking system. Seen on the VAC Facebook page. @joecoulson @verb Remember these speakers in red from Axpona?

    73537333_2458970730819438_388100138289070080_o.jpg?_nc_cat=109&_nc_ohc=dLUHz6o_9BUAQlmeSntp2lxSC4fNFSnGZryMFH-UUuiWOMmSCsPfiKAkw&_nc_ht=scontent-sjc3-1.xx&oh=feaa4cd0f48b7669642950b5d7e33fca&oe=5E85A23A

    74433505_2458971210819390_6621638637446496256_o.jpg?_nc_cat=108&_nc_ohc=0RgAnYx2gA4AQksySa-NRba6TgVluMg8yIu7P-3nJFLF7CPnV0jgWZHbQ&_nc_ht=scontent-sjc3-1.xx&oh=218b4343693606b8280ab16becf2fb28&oe=5E470C3B

    75226340_2458970757486102_1174210648175804416_o.jpg?_nc_cat=102&_nc_ohc=2tfz1NGX4QgAQmY9az17QncDU8NUIferd--Qsiu8AdCvZM3CwAWVqQLcg&_nc_ht=scontent-sjc3-1.xx&oh=e80885057b9f19b3578c0a61889aabfa&oe=5E4F8AEF

    73524551_2458970894152755_2186654484178927616_o.jpg?_nc_cat=107&_nc_ohc=5ln0DKI6YIcAQnX2QgR6mNtZ80ptf9nRCL8Pi6vJUeEFIFtVhAim2MzTA&_nc_ht=scontent-sjc3-1.xx&oh=d53e50e8a01a315d9f4ea097d2c52b38&oe=5E477222

    75184711_2458970687486109_2329563533768916992_o.jpg?_nc_cat=108&_nc_ohc=oMuzHYyx6ggAQke-n53I7RdvtjjDbEd60OwgOXxcaxgwPxRFUuSbgCpog&_nc_ht=scontent-sjc3-1.xx&oh=a1570cd79d06df6ea16fafa720df6db9&oe=5E4938B2

    72209271_2458971347486043_124328939463114752_o.jpg?_nc_cat=104&_nc_ohc=8ANhAuyHJAoAQmaMCgR0tPw_KprYT8eVuwyhBFKRsUAaNl4GaNctRoeow&_nc_ht=scontent-sjc3-1.xx&oh=a942dbc94bccbf5ace19eeb9baefb04b&oe=5E858CBB

    a4r34xq8brue.jpg

    6q28a16pkvi1.jpg

    1t5r56qxaqhk.jpg

    Those speakers I bet were 40" deep if not more. It was very hard for me to get a clear shot of them. This side shot messed with my phone camera, I have no idea why but the finish and angles had so much glare coming off from the lighting it kept making my phone lens keep trying to focus. The finish looked very deep This was the best one.

    And the Amp driving them.

    cw8shd911xl8.jpg
    umdc4sjhvlmh.jpg

    · Share on Facebook
  • Viking64
    Viking64 Posts: 7,767
    Options
    mvvmr25u3f8j.jpg
    · Share on Facebook
  • joecoulson
    joecoulson Posts: 4,969
    Options
    Ivan, that was the same one we heard at Axpona - and again, best system I have heard in my lifetime. Amazing stuff.
    · Share on Facebook
  • pitdogg2
    pitdogg2 Posts: 27,766
    Options
    Yes I was just posting the pictures to Drew's comment.
    · Share on Facebook
  • Clipdat
    Clipdat Posts: 13,101
    Options
    That vertical VAC integrated is the pinnacle of audiophile design and quality. Lust-worthy.
    · Share on Facebook
  • Clipdat
    Clipdat Posts: 13,101
    Options
    avwkk5g61x9t.jpg

    hx4vzdr8t42f.jpg

    fl47gfqmqj43.jpg
    · Share on Facebook
  • Nightfall
    Nightfall Posts: 10,083
    Options
    Roommates bike.

    0fqpx27uihr1.jpg
    onujbsnegr3j.jpg
    jwwy6y457rsh.jpg
    afterburnt wrote: »
    They didn't speak a word of English, they were from South Carolina.

    Village Idiot of Club Polk
    · Share on Facebook
  • EndersShadow
    EndersShadow Posts: 17,749
    edited November 2019
    Options
    My wife’s design handiwork....

    My Father-in-law and my labor in building the counters, and then installing everything.....

    qfea6vkn6xos.jpeg

    PS we are NOT DONE, so I already know I need to sand/fill/paint the one section and redo the backsplash to continue it all the way down on the backside...
    "....not everything that can be counted counts, and not everything that counts can be counted." William Bruce Cameron, Informal Sociology: A Casual Introduction to Sociological Thinking (1963)
    · Share on Facebook
  • joecoulson
    joecoulson Posts: 4,969
    Options
    Can I make a suggestion?
    · Share on Facebook
  • mrbiron
    mrbiron Posts: 5,721
    Options
    Building the counters......elaborate por favor.
    Where’s the KABOOM?!?! There’s supposed to be an Earth shattering KABOOM!!!
    · Share on Facebook
  • FestYboy
    FestYboy Posts: 3,861
    Options
    They appear to be epoxy coated.
    · Share on Facebook
  • EndersShadow
    EndersShadow Posts: 17,749
    Options
    joecoulson wrote: »
    Can I make a suggestion?

    You can..... but it’s already basically done lol
    "....not everything that can be counted counts, and not everything that counts can be counted." William Bruce Cameron, Informal Sociology: A Casual Introduction to Sociological Thinking (1963)
    · Share on Facebook
  • EndersShadow
    EndersShadow Posts: 17,749
    edited November 2019
    Options
    mrbiron wrote: »
    Building the counters......elaborate por favor.

    The old ones were your normal Home Depot Builder grade.

    We took those out, made our own templates and then built them out of MDF with 3/4 top and then strips underneath to provide a 1.5” lip. Then measure and cut the sink out.

    Wife then prepped and epoxied them, and then we installed them, and the sink...
    "....not everything that can be counted counts, and not everything that counts can be counted." William Bruce Cameron, Informal Sociology: A Casual Introduction to Sociological Thinking (1963)
    · Share on Facebook
  • joecoulson
    joecoulson Posts: 4,969
    Options
    Was just going to say, where you doubled in material on the edge for thickness, if you use Bondo for automotive, you will be able to get a great edge like the top surface. Otherwise over time it will start to separate. We build hundreds of MDF tops every year and use this all the time and MDF does not do well with any sort of paint on the ends without help.
    · Share on Facebook
  • EndersShadow
    EndersShadow Posts: 17,749
    Options
    joecoulson wrote: »
    Was just going to say, where you doubled in material on the edge for thickness, if you use Bondo for automotive, you will be able to get a great edge like the top surface. Otherwise over time it will start to separate. We build hundreds of MDF tops every year and use this all the time and MDF does not do well with any sort of paint on the ends without help.

    Good to know, lol.... Bit late in the game unfortunately lol...

    Does it make a difference if we used epoxy over primer?

    She ran the epoxy down the edges not just over the top.
    "....not everything that can be counted counts, and not everything that counts can be counted." William Bruce Cameron, Informal Sociology: A Casual Introduction to Sociological Thinking (1963)
    · Share on Facebook
  • joecoulson
    joecoulson Posts: 4,969
    Options
    Epoxy will help hold it together on the ends, however expect over time for the ends of the top to expand. Just humidity will do it.
    Looks great though.
    · Share on Facebook
  • EndersShadow
    EndersShadow Posts: 17,749
    edited November 2019
    Options
    joecoulson wrote: »
    Epoxy will help hold it together on the ends, however expect over time for the ends of the top to expand. Just humidity will do it.
    Looks great though.

    Gotcha. We let it drip over all the sides and the 1.5 reveal is over the entire border, not just the front. This is also a short term solution.

    We still want solid stone, just not where we can afford it right now lol....
    "....not everything that can be counted counts, and not everything that counts can be counted." William Bruce Cameron, Informal Sociology: A Casual Introduction to Sociological Thinking (1963)
    · Share on Facebook
  • mrbiron
    mrbiron Posts: 5,721
    Options
    Not bad for a Computer nerd... >:)
    Where’s the KABOOM?!?! There’s supposed to be an Earth shattering KABOOM!!!
    · Share on Facebook
  • mrbiron
    mrbiron Posts: 5,721
    Options
    aiwub40fz5dd.jpeg
    The maiden voyage has begun...
    First wall has been framed in what I am predicting to be a 2 year project.
    Where’s the KABOOM?!?! There’s supposed to be an Earth shattering KABOOM!!!
    · Share on Facebook
  • mrbiron
    mrbiron Posts: 5,721
    Options
    la2vegas wrote: »
    mrbiron wrote: »
    aiwub40fz5dd.jpeg
    The maiden voyage has begun...
    First wall has been framed in what I am predicting to be a 2 year project.

    2 year project? What's the hurry? :D

    There isn’t one, until my wife decides she wants it done.
    If I didn’t have kids, more time would be devoted to the cause. Unfortunately, the little, uh, loves of my life, consume any free time that I stumble upon. Thus, a prediction of 2 years. Could be less, but could also be WAY more.
    Where’s the KABOOM?!?! There’s supposed to be an Earth shattering KABOOM!!!
    · Share on Facebook
  • mhardy6647
    mhardy6647 Posts: 35,510
    Options
    You can come up and do mine when you're finished ;)

    · Share on Facebook