Best Of
Re: Building a vacuum tube tape preamp
I've finished wiring up the left channel from the four potentiometers to the corresponding terminals on the circuit board. The adjustments will allow for changes to the input loading, circuit gain, bass response and treble response. I connected a signal generator and meter and it seems to work, always a relief.
SeleniumFalcon
2 ·
Re: What are you cooking?
Simple supper. Most people make this with some type of ham. I like that too, but the bacon and the fat gives it a nice flavor. Just a tad of vinegar, NOT vinegary like a hot German Potato Salad. Need to use fresh green beans. Salt, pepper and I sprinkled some freeze-dried chives on top.
aprazer402
4 ·
Re: new member
…can't wait to learn from all the genius minds here.
Stop. You’re embarrassing me.
Oh, I wasn’t who you had in mind with that comment?🤣🤣🤣
PSOVLSK
9 ·
Re: Magnifi Max AX SR no indication of Dolby/DTS or anything
Hello,
Welcome to the Polk forum. I'll send a copy of your question to a friend at Polk.
Welcome to the Polk forum. I'll send a copy of your question to a friend at Polk.
SeleniumFalcon
1 ·
Re: Magnifi Max AX SR no indication of Dolby/DTS or anything
A further clarification:
"He mentions AirPlay… so tell him to press the Info button on the remote 2x to see signal information. He’s got the AX model."
"He mentions AirPlay… so tell him to press the Info button on the remote 2x to see signal information. He’s got the AX model."
SeleniumFalcon
1 ·
Re: Magnifi Max AX SR no indication of Dolby/DTS or anything
This information was provided:
On Max SR:
DTS = Yellow light
Dolby = Green light
PCM = Orange light
On Max AX :
Press info button on the remote 2t times to see current signal information
On Max SR:
DTS = Yellow light
Dolby = Green light
PCM = Orange light
On Max AX :
Press info button on the remote 2t times to see current signal information
SeleniumFalcon
1 ·
Re: Odyssey Audio Kismet power amp in Khartago case
I'll split shipping with you.
If you're interested let me know as Klaus and I are to start some trading again and this might go away sooner than expected.
If you're interested let me know as Klaus and I are to start some trading again and this might go away sooner than expected.
ALL212
1 ·
Re: 3D-printed Dreadnought case v1 (XL)
I matted the inside before bed.
I'll hook up the wires tomorrow.
I'll hook up the wires tomorrow.
plastic_avatar
1 ·