SDA-CRS/CRS+ Something Different
Options
Comments
-
You'd want to keep that monster away from the tweeter inductor.
-
Was afraid of that. Would have been nice to have all be right there accessable by 4 screws.Don't take experimental gene therapies from known eugenicists.
-
Remote mount it with faston leads to the board like Polk used.
-
Like Jesse says, you want the SuperQ as far away as possible. Difficult in the CRS cabinet though, since you don't want it near the woofer magnets either.Home Theater/2 Channel:
Front: SDA-2ATL forum.polkaudio.com/discussion/143984/my-2as-finally-finished-almost/p1
Center: Custom Built forum.polkaudio.com/discussion/150760/my-center-channel-project/p1
Surrounds & Rears: Custom Built forum.polkaudio.com/discussion/151647/my-surround-project/p1
Sonicaps, Mills, RDO-194s-198s, Dynamat, Hurricane Nuts, Blackhole5
Pioneer Elite VSX-72TXV, Carver PM-600, SVS PB2-Plus Subwoofer
dhsspeakerservice.com/ -
I'm changing out the factory inductor leads also to 16g OFC with a little extra length.
I noticed there is an "R" and a "P" on the board. Does it matter which way they are connected to factory inductor inputs?Don't take experimental gene therapies from known eugenicists. -
No
-
This is the 2nd set of factory CRS+ crossovers I've found and removed these bypass caps. Why the 1000 at 50%?
Don't take experimental gene therapies from known eugenicists. -
Probably all they had on hand at the time. It's how things worked at Polk back then.
-
Cap tolerance must have come a long way since then.Don't take experimental gene therapies from known eugenicists.
