Best Of
Re: Using other tweeter instead of RD0198-1 to replace SL2500 in Monitor 7 series 2
@Gardenstater Thanks, I'll try to clean up and smooth out the opening edge a bit to see if any improvements.
xenonsky
1 ·
Re: How do I repair my Monitor 70 Series II's - no high end?
Excellent, we like report backs 👍
F1nut
1 ·
Re: In praise of Harold Bradley
Being the most recorded guitarist ever is no small feat, and the fact that most people don’t even know his name outside music circles says a lot about how session players get overlooked. His tone and style were so smooth, it’s no wonder those records still hold up today
dogwallop
1 ·
Re: Polk crs+ Erse Super Q Inductor question
You can always go to an external back pack type build
VR3
2 ·
https://youtu.be/QuQbus0xfhk?si=Vd6toA1XFQps16Ur
Re: Maggies (1.7i) in need of a new home.
Hi Phil,
I haven't left the brand so I don't have a lot of experience with other speakers. But, I'm telling you the Polk Legend L600 has far exceeded my expectations. So make sure you don't discount their potential against higher priced speakers.
I can't think of a better 2ch/HT speaker (based on research I've read). The only problem is if you wait too long they may no longer be available.
Just my .02c
I haven't left the brand so I don't have a lot of experience with other speakers. But, I'm telling you the Polk Legend L600 has far exceeded my expectations. So make sure you don't discount their potential against higher priced speakers.
I can't think of a better 2ch/HT speaker (based on research I've read). The only problem is if you wait too long they may no longer be available.
Just my .02c
heiney9
1 ·
Re: Strange tweeter issue after recap crossover for Monitor 7 series 2
@xenonsky
Good job of tracking that down.
You may want to consider doing something in the way of securing those caps to the board.
Good job of tracking that down.
You may want to consider doing something in the way of securing those caps to the board.
slow_polk7
2 ·
Re: 6502 MW Question
Do I need to glue these magnets to the speaker frame
You should be applying the adhesive between the front and rear plates and the magnet.
F1nut
1 ·
