Best Of
Re: Can I use a dual Mono amp ( Proton d1200) with Polk SDA speakers?
skipshot12 wrote: »Did not know that.
Me has the blades.
Sure wish I could do vertical bi-amping with my blades.
Not worth horizontal, no gains.
I would choose monoblocks over a vertical bi-amp configuration.
invalid
1 ·
Re: You’re doing it wrong…
Krispy Kreme doughnuts are like meth to some people. I've been in K-K recovery for 7 years now. Not a day goes by that I don't feel the call. "Come on, you can have just one..."
msg
5 ·
Re: Side of the road find RT1000i
I like this, this is coolI also like to document projects I have completed to help build a knowledge base for people in the future with similar issues.
msg
1 ·
Re: Can I use a dual Mono amp ( Proton d1200) with Polk SDA speakers?
Excatly how many/much watts/current do tweeters need?
pitdogg2
2 ·
Re: Post a picture.....any picture...part deux...
Blasphemy! Same with the Mach-E.
jmwest1
2 ·
Re: Rig finally up and running
It takes time. You have many options! Seriously, most people don't have that many options for a dedicated rig. It will come together. Good job.
Conradicles
2 ·
Re: Side of the road find RT1000i
I don't see any warping in the plastic housing itself. I would think if it was hot enough to blacken the epoxy it would distort the plastic too.
Well there is some very high temp plastics or polymers in use. Think Glock....
pitdogg2
1 ·
Re: Speaker Gaskets - The best to use in 2025
Thanks Guys.
So my gut as a car guy was to replace all gaskets, but if you guys say if they are not torn leave it.
I dont think any of mine were damaged on removal was I'll just put the stockers right back in.
Very good intel on burning a hole vs just pushing the screw through if I had to make new gaskets.
Thanks for the continuing education (and enabling LOL).
So my gut as a car guy was to replace all gaskets, but if you guys say if they are not torn leave it.
I dont think any of mine were damaged on removal was I'll just put the stockers right back in.
Very good intel on burning a hole vs just pushing the screw through if I had to make new gaskets.
Thanks for the continuing education (and enabling LOL).
jimmypet
1 ·