Audio out?

NoObTecH
NoObTecH Posts: 22
edited February 2010 in Troubleshooting
Hi,

I'm trying to play music on my receiver from my computer through digital output (optical) which is an on board feature. However, I do not hear anything at 192k hz or 96 khz, only 48 khz and lower. Is this because of my my receiver not being able to play 192 khz?

Thank you,
Nathan
Post edited by NoObTecH on
· Share on FacebookShare on Twitter

Comments

  • mantis
    mantis Posts: 17,194
    edited February 2010
    NoObTecH wrote: »
    Hi,

    I'm trying to play music on my receiver from my computer through digital output (optical) which is an on board feature. However, I do not hear anything at 192k hz or 96 khz, only 48 khz and lower. Is this because of my my receiver not being able to play 192 khz?

    Thank you,
    Nathan

    Correct.
    Dan
    My personal quest is to save to world of bad audio, one thread at a time.
    · Share on FacebookShare on Twitter
  • NoObTecH
    NoObTecH Posts: 22
    edited February 2010
    ahhh... Thank you. I really need to fix my htr-5280 then... it's rated at 192/24 bit DAC... That should work, right?
    · Share on FacebookShare on Twitter
  • fbm211
    fbm211 Posts: 1,488
    edited February 2010
    Yes,probably
    SDA-2BTL with custom IC
    Adcom 565 monoblocks--Monarchy Audio M-10 preamp
    Theta Data Basic Transport--Stello DA100 Signature DAC--Camelot Dragon Pro2 MK III
    Harman Kardon T-55c TT
    DH Labs Q-10 Signature Speaker Cables With Furez silver plated copper bananas
    Revelation Audio Labs Prophecy Cryo-Silver Reference AES/EBU
    Revelation Audio Labs Prophecy Cryo-Silver i2s digital cable
    4 Furutech FP-314Ag with FI-11cu Plugs/FI-11AG IECs--- Power Cords
    DH LABS REVELATIONS ICs-amps
    Revelation Audio Labs Paradise cryo-silver ICs-Source to pre
    · Share on FacebookShare on Twitter
  • Phil Dawson
    Phil Dawson Posts: 288
    edited February 2010
    You might also check to see what resolution your computer is outputting.
    Phil
    · Share on FacebookShare on Twitter
  • adam2434
    adam2434 Posts: 995
    edited February 2010
    Phil Dawson wrote: »
    You might also check to see what resolution your computer is outputting.
    Phil

    +1

    What media program are you using?

    PC or Mac?

    If PC, you might want to check your supported formats in the control panel (see attached screen shot).
    sc.jpg 58.6K
    5.1 and 2.0 ch Basement Media Room: Outlaw 975/Emotiva DC-1/Rotel RB-1582 MKII/Rotel RB-1552/Audiosource Amp 3/Polk LS90, CS400i, FX500i/Outlaw X-12, LFM-1/JVD DLA-HD250/Da-Lite 100" HCCV/Sony ES BDP/Sonos Connect. DC-1/RB-1582 MKII/Sonos Connect also feed Polk 7C in garage or Dayton IO655 on patio.
    2.1 ch Basement Gym: Denon AVR-2807/Klipsch Forte I or NHT SB2/JBL SUB 550P x 2/Chromecast Audio.
    2.0 ch Living Room: Rotel RX-1052/Emotiva DC-1/Klipsch RF-7 III/Sony ES BDP/LG 65" LED.
    2.0 ch Semi-portable: Klipsch Powergate/NHT SB3/Chromecast Audio.
    Kitchen: Sonos Play5.
    · Share on FacebookShare on Twitter