Anthem Amp 1---blowing power fuse

george daniel
george daniel Posts: 12,096
edited April 2008 in Troubleshooting
:mad:Left it on last nite,, this morning --no power,,blown fuse,, replace fuse,,,power on,,blows fuse,,, unhooked pre,,, power on,, blows fuse,,I'm thinking power supply? I checked the terminals,wires,etc. Nope,, no crossed terminal connections,,etc,, anyone have any trouble shooting hints/shortcuts,, as amp/power supplies are certainly not my expertise. Thanks in advance---george
JC approves....he told me so. (F-1 nut)
Post edited by george daniel on
· Share on FacebookShare on Twitter

Comments

  • hoosier21
    hoosier21 Posts: 4,411
    edited April 2008
    is it hooked up to your newly acquired Carvers? If so, try another set of speakers and see if it does it again,
    Dodd - Battery Preamp
    Monarchy Audio SE100 Delux - mono power amps
    Sony DVP-NS999ES - SACD player
    ADS 1230 - Polk SDA 2B
    DIY Stereo Subwoofer towers w/(4) 12 drivers each
    Crown K1 - Subwoofer amp
    Outlaw ICBM - crossover
    Beringher BFD - sub eq

    Where is the remote? Where is the $%#$% remote!

    "I've always been mad, I know I've been mad, like the most of us have...very hard to explain why you're mad, even if you're not mad..."
    · Share on FacebookShare on Twitter
  • george daniel
    george daniel Posts: 12,096
    edited April 2008
    hoosier21 wrote: »
    is it hooked up to your newly acquired Carvers? If so, try another set of speakers and see if it does it again,
    negative,, it's connected to taylos monitors
    JC approves....he told me so. (F-1 nut)
    · Share on FacebookShare on Twitter
  • george daniel
    george daniel Posts: 12,096
    edited April 2008
    FWIW,,one of the EL 34's was waaaaay out of bias range,,,replaced the fuse,,rebiased,,,AND improved the ventilation,,so far so good.:)
    JC approves....he told me so. (F-1 nut)
    · Share on FacebookShare on Twitter