SDA 2A question
ScubaSteve82103
Posts: 8
I fired up the speakers the other day and there was an echo. Almost like one speaker was lagging just slightly behind the other in sound output. I tried a few different tracks and had the same thing so I shut them off to make sure I didn't damage them.
I went and started search for an SDA echo but didn't find anything that answered my question as to why. I did verify that my Onkyo 876 receiver is a common ground. The negative terminals are at .3 ohms. I also verified all my connections.
I fired them up today to try a few different tracks. I started with the same song I started with when I had the echo and it was gone. I am definitely not complaining but still curious. Any insight would be appreciated.
Thanks,
Steve
I went and started search for an SDA echo but didn't find anything that answered my question as to why. I did verify that my Onkyo 876 receiver is a common ground. The negative terminals are at .3 ohms. I also verified all my connections.
I fired them up today to try a few different tracks. I started with the same song I started with when I had the echo and it was gone. I am definitely not complaining but still curious. Any insight would be appreciated.
Thanks,
Steve
Comments
-
NO IDEA NO IDEA No Idea no idea........Political Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."
President of Club Polk -
Re-check all you connections and polarity. If you have the original blade/blade interconnect, make sure the blades and sockets are making good contact. A little DeoxIT wouldn't hurt on those connectors.Home Theater/2 Channel:
Front: SDA-2ATL forum.polkaudio.com/discussion/143984/my-2as-finally-finished-almost/p1
Center: Custom Built forum.polkaudio.com/discussion/150760/my-center-channel-project/p1
Surrounds & Rears: Custom Built forum.polkaudio.com/discussion/151647/my-surround-project/p1
Sonicaps, Mills, RDO-194s-198s, Dynamat, Hurricane Nuts, Blackhole5
Pioneer Elite VSX-72TXV, Carver PM-600, SVS PB2-Plus Subwoofer
dhsspeakerservice.com/ -
I would be betting it's your receiver. Were you in Pure Audio Mode?POLK SDA 2.3 TLS BOUGHT NEW IN 1990, Gimpod/Sonic Caps/Mills RDO-198
POLK CSI-A6 POLK MONITOR 70'S ONKYO TX NR-808 SONY CDP-333ES
PIONEER PL-510A SONY BDP S5100
POLK SDA 1C BOUGHT USED 2011,Gimpod/Sonic Caps/Mills RDO-194
ONKYO HT RC-360 SONY BDP S590 TECHNICS SL BD-1 -
I flip between pure audio and stereo but I am usually in stereo mode. It's not doing it now in Pure Audio. Can you go into details about why that might cause an issue?
