xschop

  • Re: CRS+ RestoMod

    xschopxschop
    On it's side view it is a parallelogram with each long side 8 and 3/16" long. I started with a 8.5" length then gradually cut each end til it fit snug.
    ·

  • Re: Custom CRS+ Crossovers

    xschopxschop
    You can mount them on adjacent wall with 1/2 spacers. They are set up for 194s, but if you solder in 5.8uf caps parallel to the resistor, 198's can be used.
    ·

  • CRS+ RestoMod

    xschopxschop
    Again, big thanks to @dkfreebird for dropping these off. I've looked for ages for another set to build. I'll post everything that I do to these here. Will work on these over the summer. Tho…
    ·

  • Re: CRS+ RestoMod

    xschopxschop
    1.25" solid oak dowel cross-cut 8 3/16" offset either side puts it angled and centered between front and back weak points... This clears all drivers and factory crossover. Reason why I cann…
    ·

  • Re: Post a picture.....any picture...part deux...

    xschopxschop
    Needs an LS swap.
    ·
Avatar