Monitor 10b crossover/binding post question
Options
crazifyngers
Posts: 4
I am about to redo the crossovers and l have two questions. First an most important are my binding post caps on the wrong posts? When I follow the red cap, it is plugged into the black wire internally.
I do have new binding posts but I think I’ll just leave these. Next question is do the film caps have polarity? I don’t think they do based on my research. I got Dayton audio caps. I also have new resistors and poly switch. Thanks in advance. I did search but only really say pics of the board not the binding posts.
I do have new binding posts but I think I’ll just leave these. Next question is do the film caps have polarity? I don’t think they do based on my research. I got Dayton audio caps. I also have new resistors and poly switch. Thanks in advance. I did search but only really say pics of the board not the binding posts.
Comments
-
This content has been removed.
-
I have young kids that try to be careful but they are kids. How concerned should I be about blowing a tweeter if they drop a needle wrong or decide to turn the volume up too loud? That’s my primary concern.
-
This content has been removed.
-
With Dayton caps you don't have to worry about your kids wanting to turn up the volume as they will not like the what they hear.
-
Now now- Not Tom ::::::: Any system can play Diana Krall. Only the best can play Limp Bizkit.
-
^Yea but, that was funny...
-
With SL2000's, caps are irrelevant.Don't take experimental gene therapies from known eugenicists.
-
Good point
