PSW 10 operation

Options
Burlpen77
Burlpen77 Posts: 1
in Subwoofer Hookup & Bass Management
I am new to subwoofing and at a loss to understand what the switches and dials on the back of the speaker do. I understand the volume nob that’s it. The manual is strangely silent on this. What should I set these at for best performance ?
· Share on FacebookShare on Twitter

Comments

  • stevep
    stevep Posts: 328
    Options
    lef8moov06i9.jpg

    Volume - Adjusts the output loudness. (You know it)
    Low Pass - Adjusts the crossover point for the subwoofer. Frequencies below the setting are played.
    Power - Off, Auto (On when there is a signal), On
    Phase - 0 degrees, 180 degrees (adjusts the subwoofer output like changing the wire polarity on a speaker does)
    Line In - Right and Left Pre-Amp level inputs. (Use a Y adapter for a LFE signal)
    Speaker Level Output
    Speaker Level Input - These are strapped together In to Out and feed the sub from the speaker level voltages rather than the RCA Line in level voltage on connector above.
    · Share on FacebookShare on Twitter
  • tonyb
    tonyb Posts: 32,906
    Options
    How do you have it hooked up ? By the subwoofer out connection on the back of the receiver, or by speaker wires ?
    HT SYSTEM-
    Sony 850c 4k
    Pioneer elite vhx 21
    Sony 4k BRP
    SVS SB-2000
    Polk Sig. 20's
    Polk FX500 surrounds

    Cables-
    Acoustic zen Satori speaker cables
    Acoustic zen Matrix 2 IC's
    Wireworld eclipse 7 ic's
    Audio metallurgy ga-o digital cable

    Kitchen

    Sonos zp90
    Grant Fidelity tube dac
    B&k 1420
    lsi 9's
    · Share on FacebookShare on Twitter