PSW404 connection?
Options
outlander
Posts: 218
What do you guys think would be the best way to connect my sub subwoofer to my system. The following are the speakers and receiver I have to work with.
Mains = Monitor 10Bs, set to large
Center = CSi40, set to small
Rears = FXi30, set to small
Sub = PSW404
Receiver = Yamaha HTR-5250
Currently I have the sub hooked up to the receiver with a single shielded RCA cable running from the sub out of the receiver to the LFE in on the sub with the sub crossover frequency set to the max. (180Hz). It sounds fine but I keep hearing / reading the sub should be connected to the left and right main line outs from the receiver to the two line ins on the sub.
Thanks!
O
Mains = Monitor 10Bs, set to large
Center = CSi40, set to small
Rears = FXi30, set to small
Sub = PSW404
Receiver = Yamaha HTR-5250
Currently I have the sub hooked up to the receiver with a single shielded RCA cable running from the sub out of the receiver to the LFE in on the sub with the sub crossover frequency set to the max. (180Hz). It sounds fine but I keep hearing / reading the sub should be connected to the left and right main line outs from the receiver to the two line ins on the sub.
Thanks!
O
Post edited by outlander on
Comments
-
lfe cable
80hz xover- Not Tom ::::::: Any system can play Diana Krall. Only the best can play Limp Bizkit. -
unless you go from the LFE out to the RCA ins with a y splitter....only choice i have
