Polk Audio
›

JBL 4628B Professional speakers , how can I test them?

DabutcherDabutcher Posts: 2,151
in Speakers
Just pick up a clean pair for fun and profit . Can I just hook a guitar jack into receiver headphones out and plug into one speaker to test them? I only know one person in a band and he has not gotten back to me yet? Thanks. D
MIT Magnum MH-750, Monster HTS 5100MKII, Mitsubishi rear projection 73, PS4, PSW505 , Sunfire Signature Grand 425 x 4,Parasound hca 120, RTi12, FXiA6, CSiA6, SDA SRS 1.2, Pioneer Elite SC63 , Pioneer Elite BDP-05



“Why did you get married if you wanted big speakers?”
· Share on TwitterShare on Facebook

Comments

  • kharp1kharp1 Posts: 3,410
    You probably wouldn't want to do that, but, you can get RCA to 1/4 inch cables.
    Main System:
    Joule-Electra LA 100 MKIII Upgraded by Rich Brkich Pre
    Butler Audio TBD 2250 Amp
    PS Audio DirectStream DAC and MemoryPlayer Transport
    LSA-1 Statement
    SVS SB4000 & SB2000
    Wireworld Equinox 7 bi-wire, Wireworld Silver Eclipse 7 IC

    Secondary Rig:
    Parasound P5, Audio Electronics by Cary Constellation
    Marsh a200s, Audio Elecrtonics by Cary Hercules
    Pioneer Elite DV-45a, Denon DVD-2910
    Klipsch Epic CF-1, Vandersteen 3CE sig
    Analysus Plus Oval

    Backup Gear:
    Pass Labs Aleph 30, McCormack DNA-125, Parasound A21
    Marantz SA-14S1
    Usher CP-6311/Tyler Acoustics Taylo Reference Monitor, LSA-1
    · Share on TwitterShare on Facebook
  • mhardy6647mhardy6647 Posts: 23,590
    edited October 1
    It's a passive speaker, not a powered one, right?

    And it accepts a two-conductor "TS" (tip/sleeve) type phone plug, right?

    qovbcnrk8cyc.png

    If so, you should just need to solder a 1/4 inch two conductor phone plug onto the "plus" ( via the plug's 'tip' -- the center connector) and and "minus" (via the plug's 'sleeve' -- the outer conductor) wires of a speaker cable.
    Or use a coupla clip leads.
    Or buy one.
    I always keep a few in stock :)

    · Share on TwitterShare on Facebook
  • mhardy6647mhardy6647 Posts: 23,590
    edited October 1
    Not to go all Cliff Clavin on you :# , but a standard stereo headphone plug is a three conductor connector -- so-called "TRS" (tip-ring-sleeve) -- to accommodate two 'hot' signals (two channels) and a common (ground).

    6q1bxinctj4r.png

    The TRS 1/4 inch phone plug can also be used for balanced line-level connections ("+" and "-" hot signals and a ground)... not really used for speakers per se.

    · Share on TwitterShare on Facebook
  • mhardy6647mhardy6647 Posts: 23,590
    edited October 1
    Actually, a guitar cable ought to work, as long as it is two conductor. Hard to say which channel you'll get, but it doesn't really matter.

    Also, on the bright side, the JBLs oughta be sensitive enough to play fairly well even driven from a headphone jack :)

    EDIT: mmm... those look like tonnes of fun.

    cjbkcuc3vb7s.png
    (borrowed image from teh webz)

    Don't flip 'em -- hook 'em to a nice single-ended 2A3 or 300B vacuum tube amplifier and...well... it oughta be pretty nice.

    B)


    · Share on TwitterShare on Facebook
  • DabutcherDabutcher Posts: 2,151
    Could I just hook speaker wires up to two terminals with holes in them on your picture? These are the non powered ones as in your picture. https://us.v-cdn.net/5021930/uploads/editor/0x/6q1bxinctj4r.pngm6ik99vwcig4.png
    MIT Magnum MH-750, Monster HTS 5100MKII, Mitsubishi rear projection 73, PS4, PSW505 , Sunfire Signature Grand 425 x 4,Parasound hca 120, RTi12, FXiA6, CSiA6, SDA SRS 1.2, Pioneer Elite SC63 , Pioneer Elite BDP-05



    “Why did you get married if you wanted big speakers?”
    · Share on TwitterShare on Facebook
  • mhardy6647mhardy6647 Posts: 23,590
    it depends on where the contact point is on the phone jack on the speaker.
    It will probably work, actually.
    I'd offer to beta-test it here (with clipleads!) but I don't really have time this morning due to other obligations, unfortunately.

    Clipleads are wonderful things!
    Everyone should have a bag full!
    · Share on TwitterShare on Facebook
  • mhardy6647mhardy6647 Posts: 23,590
    Didja give 'em a listen yet? :)
    Inquiring minds want to know.
    · Share on TwitterShare on Facebook
  • DabutcherDabutcher Posts: 2,151
    Worked 13 hours yesterday. Have not even unloaded from my Tundra yet. Hopefully I can figure out how to remove grills easily?
    After inspecting, I will work on figuring out how to hook up correctly without damaging. Thanks. D
    MIT Magnum MH-750, Monster HTS 5100MKII, Mitsubishi rear projection 73, PS4, PSW505 , Sunfire Signature Grand 425 x 4,Parasound hca 120, RTi12, FXiA6, CSiA6, SDA SRS 1.2, Pioneer Elite SC63 , Pioneer Elite BDP-05



    “Why did you get married if you wanted big speakers?”
    · Share on TwitterShare on Facebook
  • erniejadeerniejade Posts: 5,107
    MONO 1\4" to bare wire. . you can put a banana or spade or just use bare wire for now to test.
    Den: Lumin D1,Wireworld Silver Eclipse, KEF LS50 Wireless, Velodyne SPL1200, Technics 1200, Denon DL160, Jolida D9,

    Living Room:,T+A PA 1530R, Tyler Highland H2, Aries Mini, High Fidelity Reveal RCA, Grant Fidelity Tube Dac 11, W4S recovery, Wireworld Platinum Starlight, PS Audio Direct Stream JR.

    Have but haven't used in a while: LH Labs VI Dac, Cayin SCD50T

    · Share on TwitterShare on Facebook
  • erniejadeerniejade Posts: 5,107
    Like this one. Or make your own


    https://www.newegg.com/p/19S-01S0-00052?item=9SIAGNP8A10883&source=googleshopping&nm_mc=knc-googlemkp-mobile&cm_mmc=knc-googlemkp-mobile-_-pla-audiosavings-_-cables+-+speaker+wires-_-9SIAGNP8A10883&gclsrc=aw.ds&&gclid=Cj0KCQjwuNbsBRC-ARIsAAzITudzlDNLpl_FhX5JSD0sSMGXaQX5mEYlMQtjBByJ_3BW6dy9TDwAdUAaAnOCEALw_wcB
    Den: Lumin D1,Wireworld Silver Eclipse, KEF LS50 Wireless, Velodyne SPL1200, Technics 1200, Denon DL160, Jolida D9,

    Living Room:,T+A PA 1530R, Tyler Highland H2, Aries Mini, High Fidelity Reveal RCA, Grant Fidelity Tube Dac 11, W4S recovery, Wireworld Platinum Starlight, PS Audio Direct Stream JR.

    Have but haven't used in a while: LH Labs VI Dac, Cayin SCD50T

    · Share on TwitterShare on Facebook
  • DabutcherDabutcher Posts: 2,151
    Thanks just ordered two from amazon same price. I get them Sunday. Peace. D
    MIT Magnum MH-750, Monster HTS 5100MKII, Mitsubishi rear projection 73, PS4, PSW505 , Sunfire Signature Grand 425 x 4,Parasound hca 120, RTi12, FXiA6, CSiA6, SDA SRS 1.2, Pioneer Elite SC63 , Pioneer Elite BDP-05



    “Why did you get married if you wanted big speakers?”
    · Share on TwitterShare on Facebook
  • DabutcherDabutcher Posts: 2,151
    Thanks for all the help. Pulled grills off. They look perfect behind the screens. Outer cabinets need some black or color choice paint redu. Anyone know where to buy black paint? Heavy suckers. I would guess 80-100 pounds each. 2a8ex95axmkn.jpeg
    Peace. D
    MIT Magnum MH-750, Monster HTS 5100MKII, Mitsubishi rear projection 73, PS4, PSW505 , Sunfire Signature Grand 425 x 4,Parasound hca 120, RTi12, FXiA6, CSiA6, SDA SRS 1.2, Pioneer Elite SC63 , Pioneer Elite BDP-05



    “Why did you get married if you wanted big speakers?”
    · Share on TwitterShare on Facebook
  • mhardy6647mhardy6647 Posts: 23,590
    If it were anything but black paint...

    · Share on TwitterShare on Facebook
  • DabutcherDabutcher Posts: 2,151
    Finally getting around to testing these bad boys. Which of the three connectors do I hook up to? Thanks. Donyxe8eoy42i.jpeg
    MIT Magnum MH-750, Monster HTS 5100MKII, Mitsubishi rear projection 73, PS4, PSW505 , Sunfire Signature Grand 425 x 4,Parasound hca 120, RTi12, FXiA6, CSiA6, SDA SRS 1.2, Pioneer Elite SC63 , Pioneer Elite BDP-05



    “Why did you get married if you wanted big speakers?”
    · Share on TwitterShare on Facebook
  • mhardy6647mhardy6647 Posts: 23,590
    edited October 19
    hmmm -- it looks like (???) there's no full range input (?!).

    Is there something under that piece of blue painter's tape? :p

    If there is, I'd use that, otherwise, I'd try pluggin' in to that (apparently) "8 ohm low frequency input" and see if you only 'excite' the woofas (which is presumably what'll happen).

    Seems like they 'want to be' biamplified... which is certainly an option to try 'em out! :)

    · Share on TwitterShare on Facebook
Sign In or Register to comment.

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

Sign In Register

Quick Links

© Polk Audio 2014