Monitor 7C crossover question

I recently bought a set of the Monitor 7C speakers and hooked up yesterday, everything sounded ok. So i pulled out the crossovers to verify the components match the wiring schematic. I am going to upgrade the caps/resistor. Today I noticed the Polyswitch appears to have been clipped off on both. Unless a jumper has been placed on the circuit then that tweeter circuit should be open. Looking at the boards I cant tell. Anyone see a possible jumper, if not can you suggest something? Ideas? There is no fuse on the terminal cups.
Thanks!
7frreh7i1twc.jpg
0l9mx0a9gq9e.jpg
l7vayurnjwzi.jpg
l47rwm7tnljc.jpg
36b7gl4d3nj8.jpg
kf8x57gvgytr.jpg

SDA 1C- Vr3 Mods/ Gimpod, Larry's rings, RDO194 tweeters, etc.

Comments

Sign In or Register to comment.

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!