Silly question...

FestYboy
FestYboy Posts: 3,861
edited June 2018 in 2 Channel Audio
I was having a brain f-art the other night and pondered to myself: why is it that only the pin-blade SDAs can use the AI-1 or dreadnought? Why can't we employ the same tech to each wire of the blade-blade SDAs? It's just a matter of transformer decoupling, as is used with the AI-1 and dreadnought, so why not double it?
Post edited by FestYboy on
· Share on FacebookShare on Twitter

Comments

  • F1nut
    F1nut Posts: 49,781
    AI-1

    Dreadnought

    Pin/blade

    Blade/blade

    Now that we have the correct terms, the reason the blade/blade versions cannot use the AI-1 or Dreadnought is because of the crossover circuit design.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter
  • msg
    msg Posts: 9,424
    The White Van versions use the AI-C or Dreadnautica (smells good, despite the name), and the Pin/Pin.
    The Blade only comes up when you try to back out of the sale.
    I disabled signatures.
    · Share on FacebookShare on Twitter
  • FestYboy
    FestYboy Posts: 3,861
    Corrections employed.

    Ok, Jesse, I'll have to review the XO designs again. I must have missed something during the f-art :/
    · Share on FacebookShare on Twitter
  • boston1450
    boston1450 Posts: 7,451
    Scott i cant stop laughing :) too funny
    ..
    ..
    ..
    Randy/Maine
    · Share on FacebookShare on Twitter