A bit of a modern twist on a classic

So a bit of an update.

I was installing the T-nuts to the PR and noticed when i taped the nut in that the front panel was loose. To the point i could see daylight on the join of the bottom panel. The original glue (which was a black silastic) had failed and i could pull the front panel and the trim beads off completely. So i checked the other box and while not as bad it was also loose where the front and bottom panels met.

To cut a long story short i clean off as much of the original silastic as i could with a Stanley box cutter blade and re glued the box back together. I also sealed all the joins on the inside of the boxes and clamped it all together to dry.

So hopefully this will fix up the bass side of things.

Sorry yes it was Hurricane nuts same as theses.http://www.amazon.com/gp/product/B0002ZPETA

When i say tap them in I'm mean gently taping with a soft (nylon) hammer. I could feel that the front panels was loose.

I like to use a slightly under size drill bit so the nuts bite into the wood.

I don't want to paint the picture that i was bashing them in.
But I'm glad i did because i discovered a problem i doubt i would have found otherwise.

Noted.

Thanks lawdogg but I'm sorted.