Lsifx
Ok im having troble getting a pair of fxi50's for my surround speakers (going to put the 30's in the rear.
My question is will the LSiFX blend in with the setup i have or not work well?
Dan
My question is will the LSiFX blend in with the setup i have or not work well?
Dan
Recever AVR 8000
Amp PA 4000
CDR 26
Mains RTI 150 Bi wired
Center CSI 40 Bi wired
Surround FXI 30
Rear RTI 4
Sub PSW 140
Amp PA 4000
CDR 26
Mains RTI 150 Bi wired
Center CSI 40 Bi wired
Surround FXI 30
Rear RTI 4
Sub PSW 140
Post edited by Fireman99 on
Comments
-
I just got a pair of FXi50's from Crutchfield for $350 last week. They should still have some...
AFLMains: Polk RTi70's
Center: Polk CSi40
Surrounds: Polk FXi 50's
Sub: SVS 20-39PCi
Receiver: JVC RX-DV3SL -
I can't see why they wouldn't blend.
There isn't THAT much surround audio.LSi 9/C/FX
Arcam AVR-200 -
Final answer is NODan
My personal quest is to save to world of bad audio, one thread at a time. -
I'm going to say no as well, but will also tell you why.
The RT line up are 8 ohm speakers, the Lsi are 4 ohm speakers. That could cause you some problems right off the bat.
Second is that the Lsi series use Vifa Ring Radiator Tweeters, your Rt seies do not. They are in no way, shape, or form timbre matched. Yes it does make a difference, but how much is debatable. My opinion is that for the best possible sound, use matching speakers. Rt with Rt, Lsi with Lsi.
Hope this helps. -
Thank-you Frank I was looking into the 4ohm deal to see if that was a problem. And I wasnt sure about the Tweeter how much it would be diffrent since I have not been able to listen to any LSI speakers =(.
Living in Canada I think the online retailers are out for me I'll end up paying 3x the cost with shipping and duty brokerage fees etc. and I picked up my FXI30's for $250 cdn just cant find a pair of 50s.
DanRecever AVR 8000
Amp PA 4000
CDR 26
Mains RTI 150 Bi wired
Center CSI 40 Bi wired
Surround FXI 30
Rear RTI 4
Sub PSW 140 -
Dan,
Have you considered putting the 30's on the sides and using a pair of direct radiating speakers on the rear wall? A pair of 28's would work very well for rear channel duty, and they would probably cost less thana pair of 50's. -
Thanx again frank I'm going over to take a look and listen to the 28's and 38's today and see if they will do the job sounds like a good opiton though.
DanRecever AVR 8000
Amp PA 4000
CDR 26
Mains RTI 150 Bi wired
Center CSI 40 Bi wired
Surround FXI 30
Rear RTI 4
Sub PSW 140