Project RM-5 Custom Made Aluminum Clamp
Options
BaggedLancer
Posts: 6,371
Found this while cleaning out the closet. A machinist friend of mine made this for my Project RM-5 table(now sold). It's made out of aluminum, has a few minor surface scuffs that should polish out. They aren't gouges, just the "scuffs" that raw aluminum gets.
Be a nice piece to anodize or just polish and use as is.
$80/obo takes it
Be a nice piece to anodize or just polish and use as is.
$80/obo takes it
Post edited by BaggedLancer on
Comments
-
-
Is it much different than the standard clamp that comes with the RM-5?
Thanks. -
PM sent.
-
-
PM has been returned, Dawgfish was inquiring about it fitting a Technics table. I have no idea. I know it fits an RM5.
-
Does anybody know if this would fit a Technics SL-1200 MK2? Thanks in advance.
-
Mark is that clamp threaded?
-
engtaz,
I believe I'm just going to go ahead and get a clamp specifically made for the 1200, so if you want to take a crack at getting the clamp, by all means go right ahead. Baggedlancer, thanks for your replies. I hope everything works out with your sale.
Steve -
Except for the colour it looks identical to my Pro-ject 6.9 standard clamp, so I would take a very logical guess and say "yes" it is threaded.SDA-1C (full mods)
Carver TFM-55
NAD 1130 Pre-amp
Rega Planar 3 TT/Shelter 501 MkII
The Clamp
Revox A77 Mk IV Dolby reel to reel
Thorens TD160/Mission 774 arm/Stanton 881S Shibata
Nakamichi CR7 Cassette Deck
Rotel RCD-855 with modified tube output stage
Cambridge Audio DACmagic Plus
ADC Soundshaper 3 EQ
Ben's IC's
Nitty Gritty 1.5FI RCM -
i'm out thanks for the chance.engtaz
I love how music can brighten up a bad day. -
oooh, that would make a nice head smacker.
-
Price drop to $60.
-
Is it much different than the standard clamp that comes with the RM-5?
Thanks.
Same question(s).
Is it threaded/heavier/otherwise different?
Thanks. -
Threaded, a little heavier, looks cooler and you can finish it how you want.