about to hook up a PSW505--need a little help

dl090465

Hello Everyone,

I am about to hook up a PSW505 on the wall where my FXi30 surrounds are, far from the receiver. I want to use the speaker wires for signal. In this case, do I set my receiver to LARGE rather than small and let the crossover in the PSW505 do the rest when it outputs to the FXi30's ???

Thanks for any input,

Dave

packetjones

Just to make sure I understand the question. You are wanting to connect the sub to the speaker wire running to your surrounds?

As far as i know to use the high level inputs on the sub. it would need to be the connections for your fronts not the surrounds. i could be wrong though. Soem others should chime in shortly to clarify.

dl090465

Yes, I want to use the surrounds for my signal so as to not have to run any additional wires....my receiver is a 7 channel receiver and the power output is the same on all seven channels....

hopefully someone can tell me if this is feasible!!!!!

Thanks!!!!