Any reason to bi-amp my cs400?

kelley
kelley Posts: 287
edited November 2009 in Speakers
I've got one of my amps bridged right now to run 200wpc into the center. I can always go back to 100x2 and biamp the center but without a crossover will it make any difference?
SDS-400, SDA-1B, SVS 20-39pc+, B&K Ref 50, Denon 2900
Post edited by kelley on
· Share on FacebookShare on Twitter

Comments

  • mantis
    mantis Posts: 17,206
    edited April 2003
    have you tried it both ways?
    Dan
    My personal quest is to save to world of bad audio, one thread at a time.
    · Share on FacebookShare on Twitter
  • kelley
    kelley Posts: 287
    edited April 2003
    No I haven't. I wouldn't even have considered it but my new, or new to me, processor has a left and right output for the center and when I hooked it up I entertained the thought but then decided against it. I'm not really set up to where I want to be as far as listening to movie tracks just yet so I'm not sure I would get a fair assesment.
    SDS-400, SDA-1B, SVS 20-39pc+, B&K Ref 50, Denon 2900
    · Share on FacebookShare on Twitter
  • bigsexy1
    bigsexy1 Posts: 557
    edited April 2003
    I think you would hear a subltle improvement. Go ahead and try it.
    · Share on FacebookShare on Twitter
  • Polkie2009
    Polkie2009 Posts: 3,834
    edited November 2009
    Since I have a Adcom 545 not being used, I got the idea to put it to use powering my center channel speaker.(CS-400) Anyone try bi-amping a Polk CS-400? Have the Yammy HTR6160 (663) as a AVR.
    · Share on FacebookShare on Twitter