POLK SR-H1000 and "Pass-through" mode

Chinook007
Chinook007 Posts: 1
edited June 2009 in Troubleshooting
Anyone have an idea if there is a fix or a patch for this oversight. Power cycle disables "Pass-through" mode, defaults to IR and front panel operation only (no RS-232). The user must manually go into the "diagnostic page" and enable it again. Functionality this is extremely limiting when putting it in a control system like AMX, as you will not get any feedback what so ever unless you have a television in front of you.

Thoughts anyone ?
· Share on FacebookShare on Twitter

Comments

  • [Deleted User]
    [Deleted User] Posts: 7,658
    edited June 2009
    Hello,
    From my understanding of the SR-H1000 operation, having a power cycle will return the unit out of the "pass-through" mode. I don't believe there are any firmware changes that will address this. I'm sorry for the inconvenience.
    Regards, Ken
    · Share on FacebookShare on Twitter