Onkyo TX-DS989Ver2 vs. Denon 4802

Options
2»

Comments

  • mantis
    mantis Posts: 17,056
    edited March 2003
    Options
    Doc,
    have you tried lowering the cut off to 60 Hz???I bet the Polk system would love that.Alittle juice and the Denon will supply....
    Dan
    My personal quest is to save to world of bad audio, one thread at a time.
    · Share on FacebookShare on Twitter
  • Dr. Spec
    Dr. Spec Posts: 3,780
    edited March 2003
    Options
    I tried 60 Hz and honestly 80 Hz sounds a tad better even for music - only because the SVS is such a good subwoofer.

    It is amazing I can do filter point shifts on the fly while listening to music for instant comparo's. What a flexible AVR this is.

    Dan - check my previous recent post over on page one - looking for wire recommendations per your comments - you might have missed that post and I'd like your thoughts (and anyone else's).

    Doc
    "What we do in life echoes in eternity"

    Ed Mullen (emullen@svsound.com)
    Director - Technology and Customer Service
    SVS
    · Share on FacebookShare on Twitter
  • mantis
    mantis Posts: 17,056
    edited March 2003
    Options
    Doc,
    god where do I start........Ok lets get to basic's....

    Your level of system would greatly benefit from Monster M950i interconnects and M1.4s bi wire speaker cable.Thats the Monster of things.
    Try out some KimberKable PPJ's interconnects and 4vs/8vs bi wires.Kimber Kable has Proven to me to be one of the very best sounding wires around.
    You would benefit from experiment.See if any local dealers will allow you to take some home and try it.
    Get into it and I'll try to help further.
    Dan
    My personal quest is to save to world of bad audio, one thread at a time.
    · Share on FacebookShare on Twitter