Polk PA1200.1 - keeps cutting out and in...

Kiran
Kiran Posts: 9
edited February 2009 in Troubleshooting
Hey guys, I've got a rather annoying problem with my Polk PA1200.1 Monoblock amp. when I play it at high volumes it just cuts out after about half an hour or an hour of listening time!!!!! Its connected to my alpine CDA9987 and powers a Polk SR124DVC subwoofer. The blue lights and everything are still on, so I know its still powered up, but it just doesn't deliver anything to my sub!! It comes back to life a day or two later, and its like nothing happened at all...until it just cuts out again when I listen to loud music! It doesn't seem to be excessively hot so I dont think its over heating, and my gain is only set to about half since I dont like a very loud low end. I'm totally lost as to whats happening and I'm about ready to rip this amp out and go with another brand - JL audio or ARC audio.... Anyone who knows anything about this - please help!!!:confused:
Polk SR 6500 (front)
Polk SR 6500 (rear)
Polk SR 124 DVC
Polk1200.1 Monoblock
ARC Audio SE 4200(signature edition 4 channel Amp)
/////Alpine PXE-H650 Imprint Processor (returned to Crutchfield...didnt sound as good as its slated out to be!)
/////Alpine CDA-9887
Jamo 2.5mm home theater spkr wires, Monster RCA's
Post edited by Kiran on
· Share on FacebookShare on Twitter

Comments

  • comfortablycurt
    comfortablycurt Posts: 6,745
    edited February 2009
    You'd probably get more response posting this in the car audio section of the forum.

    By the way, welcome to Club Polk.:)
    The nirvana inducer-
    APC H10 Power Conditioner
    Marantz UD5005 universal player
    Parasound Halo P5 preamp
    Parasound HCA-1200II power amp
    PolkAudio LSi9's/PolkAudio SDA 2A's/PolkAudio Monitor 7A's
    Audioquest Speaker Cables and IC's
    · Share on FacebookShare on Twitter