alpine type-r + pa500.4

elz88
elz88 Posts: 5
edited December 2008 in Troubleshooting
Ok, i need some help! i have a one alpine type-r (swr-1242d) and a polk audio pa500.4, at first i had my cab running at 2 ohms with my amp bridged and i was wondering my my sub kept cutting out when i turned up the volume, i thought have might be a bad ground connection but after looking through the manuals the amp was pushing out 4 ohms which is bad right? so the only other option was to run my cab at 8 ohms with my amp running at 4 ohms bridged. it fine, but i not getting the full power out of my sub!!! is this bad? is there a way to match up my sub and my amp and the same ohms?
Post edited by elz88 on
· Share on FacebookShare on Twitter

Comments

  • wutadumsn23
    wutadumsn23 Posts: 3,702
    edited December 2008
    Looks like you posted this everywhere but the automotive, lol.
    HT Rig
    Receiver- Onkyo TX-SR806
    Mains- Polk Audio Monitor 70
    Center- Polk Audio CS2
    Surrounds- Polk Audio TSi 500's :D
    Sub- Polk Audio PSW125
    Retired- Polk Audio Monitor 40's
    T.V.- 60" Sony SXRD KDS-60A2000 LCoS
    Blu-Ray- 80 GB PS3


    2 CH rig (in progress)
    Polk Audio Monitor 10A's :cool:

    It's not that I'm insensitive, I just don't care.. :D
    · Share on FacebookShare on Twitter