SDA 1 Tweeter not working

derek_murray
derek_murray Posts: 41
edited October 2008 in Troubleshooting
I recently noticed that my speakers were sounding off. A little trial and error and I realized that the stereo tweeter in my right channel speaker was not working. It is not blown as I switched it out with the dimesional speaker that is working and it worked in it's place. It seems to me that there must be some sort of crossover problem. Any suggestions of other things to check?
Post edited by derek_murray on
· Share on FacebookShare on Twitter

Comments

  • zingo
    zingo Posts: 11,258
    edited September 2008
    First, I would check all the connections between the tweeter and the crossover. Then all the connections on the crossover. Just see if anything is loose or came off.
    Jake
    · Share on FacebookShare on Twitter
  • thebluemonkey
    thebluemonkey Posts: 190
    edited October 2008
    Im having the same problem the tweets will stop working and if you tap the cabnit they will start working again.I have checked all the connections and everything ok. could it be a cold solder joint on the crosover?
    · Share on FacebookShare on Twitter
  • F1nut
    F1nut Posts: 50,557
    edited October 2008
    The SDA I use fuses for tweeter protection. Check the fuses and clean the fuse holders.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter
  • george daniel
    george daniel Posts: 12,096
    edited October 2008
    jump it ;)
    JC approves....he told me so. (F-1 nut)
    · Share on FacebookShare on Twitter