Pop goes the receiver

NeilGabriel
NeilGabriel Posts: 1,487
edited June 2008 in Troubleshooting
I jsut got my AVR back from the mfr who fixed a problem with one channel and did an overhaul and software upgrade. I hooked it up to one system when I got it back and then moved it to another system. When it goes from sleep to full power or back to sleep I get an audible pop through the speakers. I didn't notice if this occurred when I fist hooked it up or after I moved it. This was not the problem I sent it in for. Is this most likely a wiring issue on my part??
Thanks.
Post edited by NeilGabriel on
· Share on FacebookShare on Twitter

Comments

  • disneyjoe7
    disneyjoe7 Posts: 11,435
    edited June 2008
    Interesting, what brand are we talking about?

    Speakers
    Carver Amazing Fronts
    CS400i Center
    RT800i's Rears
    Sub Paradigm Servo 15

    Electronics
    Conrad Johnson PV-5 pre-amp
    Parasound Halo A23
    Pioneer 84TXSi AVR
    Pioneer 79Avi DVD
    Sony CX400 CD changer
    Panasonic 42-PX60U Plasma
    WMC Win7 32bit HD DVR


    · Share on FacebookShare on Twitter
  • NeilGabriel
    NeilGabriel Posts: 1,487
    edited June 2008
    Was away on vacation. Could use another. This is a B&K AVR 202. I also have a B&K pre/pro 20 and it is dead quiet when turned off and on. I have not had a chance to put it back in other system. It is a bit of a chore. The pop is a bit louder when it powers on than when it powers off. I have experienced this with other equipment over the years.
    · Share on FacebookShare on Twitter