Shortie Speaker Stands

BaggedLancer
BaggedLancer Posts: 6,371
edited November 2007 in Wanted (WTB) Classifieds
Checked www.racksandstands.com
Checked www.ebay.com
Checked www.craigslist.com

I want something like the attached pictures. My intention is to cut them down to about 5-6 inch stands and use them on top of a bureau so they must be able to be taken apart. Wood or metal is fine, I have enough tools I can cut either. I found these on craigslist but they are just too far away from me to make the non negotiable trip worthwhile.

Thanks,
Mark
Post edited by BaggedLancer on
· Share on FacebookShare on Twitter

Comments

  • Kex
    Kex Posts: 5,191
    edited November 2007
    BaggedLancer, I bought some gear recently of a guy who had four short stands. I think they were wood, painted black. They looked like good quality and I don't think they were more than 12" off the ground. I'll pop him an e-mail today to see if he still has them and ask if he has any pix. I know he intended to sell them. I'll keep you posted.
    Alea jacta est!
    · Share on FacebookShare on Twitter
  • BaggedLancer
    BaggedLancer Posts: 6,371
    edited November 2007
    Awesome thanks.
    · Share on FacebookShare on Twitter
  • VR3
    VR3 Posts: 28,644
    edited November 2007
    istockphoto_2609203_plastic_cups.jpg
    - Not Tom ::::::: Any system can play Diana Krall. Only the best can play Limp Bizkit.
    · Share on FacebookShare on Twitter
  • BaggedLancer
    BaggedLancer Posts: 6,371
    edited November 2007
    .....
    · Share on FacebookShare on Twitter
  • VR3
    VR3 Posts: 28,644
    edited November 2007
    A cup is about 5-6"...

    Just fill them with stand -- wrap bottom with plastic (rubber band around the bottom to seal)

    Turn it upside down, put speaker on top -- use two cups per speaker if you want to go high end...

    Awesome stuff
    - Not Tom ::::::: Any system can play Diana Krall. Only the best can play Limp Bizkit.
    · Share on FacebookShare on Twitter
  • Face
    Face Posts: 14,340
    edited November 2007
    Or you could use a few of these. :D
    Brick.jpg
    "He who fights with monsters should look to it that he himself does not become a monster. And when you gaze long into an abyss the abyss also gazes into you." Friedrich Nietzsche
    · Share on FacebookShare on Twitter
  • Kex
    Kex Posts: 5,191
    edited November 2007
    Kex wrote: »
    BaggedLancer, I bought some gear recently of a guy who had four short stands. I think they were wood, painted black. They looked like good quality and I don't think they were more than 12" off the ground. I'll pop him an e-mail today to see if he still has them and ask if he has any pix. I know he intended to sell them. I'll keep you posted.
    Ok, so he responded to my message, but he has already sold these stands. Sorry!
    Alea jacta est!
    · Share on FacebookShare on Twitter
  • BaggedLancer
    BaggedLancer Posts: 6,371
    edited November 2007
    thanks anyway kex

    What i thought was going to be a fairly common thing of "table stands" it seems only Bose jumped on this bandwagon....
    · Share on FacebookShare on Twitter