Installing new Drivers for CSi3

dhicks444

I can't seem to find the right size Hex/L wrench to replace the blown drivers of my csi3. I have used 2.5 and size 3. Any suggestions? Thanx

mrbigbluelight

Sounds like you've been trying to use METRIC hex keys.

Try standard.

If you've tried a 2.5 and a 3.0 mm hex key, I bet the 2.5 was too small, and the 3 was too big; use a 1/8" standard, and I think you'll find it juuuusssst
right.

If not, try a kitchen knife, The Universal Tool.

dhicks444

Thx BigBlue. I'll search for one tomorrow.