Single SR 10 sub. Which amp?

2»

Comments

  • killerb
    killerb Posts: 390
    edited September 2006
    the new xtant isnt the same quality as the oldschool xtant.
    kenwood excelon kdc-x991 h.u.
    Rockford Fosgate 360.3 DSP
    Rockford Fosgate POWER1000 running entire system
    Image Dynamics IDQ12 Sub
    Morel Elate 6 front stage
  • MacLeod
    MacLeod Posts: 14,358
    edited September 2006
    Yes it is. Actually its better. Mitek is legendary for their bulletproof build quality. MTX amps and subs are virtually indestructible and Xtant is no exception. Id stack up the new line against the old line anyday.
    polkaudio sound quality competitor since 2005
    MECA SQ Rookie of the Year 06 ~ MECA State Champ 06,07,08,11 ~ MECA World Finals 2nd place 06,07,08,09
    08 Car Audio Nationals 1st ~ 07 N Georgia Nationals 1st ~ 06 Carl Casper Nationals 1st ~ USACi 05 Southeast AutumnFest 1st

    polkaudio SR6500 --- polkaudio MM1040 x2 -- Pioneer P99 -- Rockford Fosgate P1000X5D
  • Toxis
    Toxis Posts: 5,116
    edited September 2006
    I think Xtant is every bit as good if not better than they used to be.

    MTX on the other hand might be as if not more durable than years past, the sound quality has taken a HUGE step down. Basically fell right off the ladder. Not to mention they're ugly as piss. Almost as bad as the PPI **** series.
    Never kick a fresh **** on a hot day.

    Home Setup: Sony VPL-VW85 Projo, 92" Stewart Firehawk, Pioneer Elite SC-65, PS3, RTi12 fronts, CSi5, FXi6 rears, RTi6 surround backs, RTi4 height, MFW-15 Subwoofer.

    Car Setup: OEM Radio, RF 360.2v2, Polk SR6500 quad amped off 4 Xtant 1.1 100w mono amps, Xtant 6.1 to run an eD 13av.2, all Stinger wiring and Raammat deadener.
  • killerb
    killerb Posts: 390
    edited September 2006
    i had a new xtant amp and it took a crap in less than 6 months. my oldschool rockford punch 40, 60 and 200 amps are still in my girls car now. my carver amp is in my car and running my sr6500 set after 10 plus years. that is durability and build quality. most of these amps today are cheaply made paperweights. buy quality once and have it forever.
    kenwood excelon kdc-x991 h.u.
    Rockford Fosgate 360.3 DSP
    Rockford Fosgate POWER1000 running entire system
    Image Dynamics IDQ12 Sub
    Morel Elate 6 front stage
  • MacLeod
    MacLeod Posts: 14,358
    edited September 2006
    You mustve gotten a lemon.

    As for MTX's sound quality, I dont see how MTX could be much better! Their signal to noise ratios are routinely in the 120's and they exceed their ratings by half with zero distortion! You cant ask anymore from an amp SQ wise than that.
    polkaudio sound quality competitor since 2005
    MECA SQ Rookie of the Year 06 ~ MECA State Champ 06,07,08,11 ~ MECA World Finals 2nd place 06,07,08,09
    08 Car Audio Nationals 1st ~ 07 N Georgia Nationals 1st ~ 06 Carl Casper Nationals 1st ~ USACi 05 Southeast AutumnFest 1st

    polkaudio SR6500 --- polkaudio MM1040 x2 -- Pioneer P99 -- Rockford Fosgate P1000X5D
  • killerb
    killerb Posts: 390
    edited September 2006
    i might have, but i will never buy another one. i wont have to with the amps i have now.
    kenwood excelon kdc-x991 h.u.
    Rockford Fosgate 360.3 DSP
    Rockford Fosgate POWER1000 running entire system
    Image Dynamics IDQ12 Sub
    Morel Elate 6 front stage
  • Toxis
    Toxis Posts: 5,116
    edited September 2006
    MacLeod wrote:
    As for MTX's sound quality, I dont see how MTX could be much better! Their signal to noise ratios are routinely in the 120's and they exceed their ratings by half with zero distortion! You cant ask anymore from an amp SQ wise than that.
    Come on mac, you know better than this. Once you start looking at the stats that hardcore, you stopped listening to the amp. Period.
    Never kick a fresh **** on a hot day.

    Home Setup: Sony VPL-VW85 Projo, 92" Stewart Firehawk, Pioneer Elite SC-65, PS3, RTi12 fronts, CSi5, FXi6 rears, RTi6 surround backs, RTi4 height, MFW-15 Subwoofer.

    Car Setup: OEM Radio, RF 360.2v2, Polk SR6500 quad amped off 4 Xtant 1.1 100w mono amps, Xtant 6.1 to run an eD 13av.2, all Stinger wiring and Raammat deadener.
  • MacLeod
    MacLeod Posts: 14,358
    edited September 2006
    Those specs are hard to miss as theyre printed on each amps birthsheets!
    polkaudio sound quality competitor since 2005
    MECA SQ Rookie of the Year 06 ~ MECA State Champ 06,07,08,11 ~ MECA World Finals 2nd place 06,07,08,09
    08 Car Audio Nationals 1st ~ 07 N Georgia Nationals 1st ~ 06 Carl Casper Nationals 1st ~ USACi 05 Southeast AutumnFest 1st

    polkaudio SR6500 --- polkaudio MM1040 x2 -- Pioneer P99 -- Rockford Fosgate P1000X5D
  • Greg Peters
    Greg Peters Posts: 605
    edited September 2006
    killerb wrote:
    i have the sr124-dvc and am going to use my zapco c2k-3.0 rated at 600 watts into 2 ohm bridge. in real life it puts out about 700 watts. its expensive, but they are rock solid amps with a damping factor of over 1000 to really control cone movement.

    So- how does it sound?

    Waiting (im)patiently for an update on your opinion of the SR124-DVC.
  • killerb
    killerb Posts: 390
    edited September 2006
    it sounds breathtaking! super tight with great detail and it gets loud. i sold my jl12w7 to get this sub and i dont regret it at all. cant ask for anything more.
    kenwood excelon kdc-x991 h.u.
    Rockford Fosgate 360.3 DSP
    Rockford Fosgate POWER1000 running entire system
    Image Dynamics IDQ12 Sub
    Morel Elate 6 front stage
  • Toxis
    Toxis Posts: 5,116
    edited September 2006
    how's it perform in output comparison to the Dub7?
    Never kick a fresh **** on a hot day.

    Home Setup: Sony VPL-VW85 Projo, 92" Stewart Firehawk, Pioneer Elite SC-65, PS3, RTi12 fronts, CSi5, FXi6 rears, RTi6 surround backs, RTi4 height, MFW-15 Subwoofer.

    Car Setup: OEM Radio, RF 360.2v2, Polk SR6500 quad amped off 4 Xtant 1.1 100w mono amps, Xtant 6.1 to run an eD 13av.2, all Stinger wiring and Raammat deadener.