replacing push in terminals on monitor 4.6
catzcradle
Posts: 13
I've got a pair of monitor 4.6's and wanted to replace the back plate with a 5-way binding post version. I have the new back-plate, but when I pull the original out, the crossover and backplate are one assembly. Is there some way to seperate the terminal plate and mount the new one, or should I just leave it alone?
HT System:
Outlaw Audio model 1070 Receiver
Sony DVP-70 DVD
Dish 611 HD DVR
Polk SRS 3.1 mains
Polk Monitor 4.6 series 2 Side surrounds
Polk Monitor 5Jr Rear surrounds
Polk CS-350 Center
SVS PCi 20-89 Sub
Outlaw Audio model 1070 Receiver
Sony DVP-70 DVD
Dish 611 HD DVR
Polk SRS 3.1 mains
Polk Monitor 4.6 series 2 Side surrounds
Polk Monitor 5Jr Rear surrounds
Polk CS-350 Center
SVS PCi 20-89 Sub
Post edited by catzcradle on
Comments
-
Can you post a pic?Political Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."
President of Club Polk -
There may be a screw or hex bolt that holds the crossover to the old "backplate". As mentioned previously, a picture would help.
Do they look like this?CTC BBQ Amplifier, Sonic Frontiers Line3 Pre-Amplifier and Wadia 581 SACD player. Speakers? Always changing but for now, Mission Argonauts I picked up for $50 bucks, mint. -
Yep, thats them.
Well, I got adventurous, and found that they were basically hot-melted and soldered onto the terminal plates. So, I was able to unsolder them and replace them that way, and they seem to be fine. Didn't think of posting a picture for some reason.HT System:
Outlaw Audio model 1070 Receiver
Sony DVP-70 DVD
Dish 611 HD DVR
Polk SRS 3.1 mains
Polk Monitor 4.6 series 2 Side surrounds
Polk Monitor 5Jr Rear surrounds
Polk CS-350 Center
SVS PCi 20-89 Sub
