Tweeter problem but not polyswitch
jasonkodat
Posts: 2
Hello all,
I've searched a bit. My mids are fine. Both tweeters worked in the one speaker (they're Monitor 5's) but neither tweeter worked in the other speaker, so I called and ordered polyswitches. They came in and I opened up my crossover.
Voila, no polyswitch at all on my crossover.
Is there something else I can check or am I just better off replacing the whole crossover at this point?
Thanks,
Jason
I've searched a bit. My mids are fine. Both tweeters worked in the one speaker (they're Monitor 5's) but neither tweeter worked in the other speaker, so I called and ordered polyswitches. They came in and I opened up my crossover.
Voila, no polyswitch at all on my crossover.
Is there something else I can check or am I just better off replacing the whole crossover at this point?
Thanks,
Jason
Post edited by jasonkodat on
Comments
-
Check the fuse on the binding post plate.Political Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."
President of Club Polk -
F1nut,
The fuse was the first thing I checked since they're outside, and it didn't look blown, so I ignored it. It must've just been making bad contact, I swapped the fuses and now both tweeters work.
<sigh> And to think I could have avoided pulling out all my hair just by doing one more swap...
Thanks. -
Ah ha!
I'm glad it was a simple fix. You might want to go back and clean the fuse ends (or buy new ones) and the clips really well. I'm sure they have plenty of oxidation after all these years.Political Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."
President of Club Polk -
Memo to self: Always check the easiest thing first....
I've looked a fuses and not seen breaks at the extreme end of them. So now I check them with my trusty, old Rat Shack VOM...
Glad you're back in the tunes, jasonkodat. A pencil eraser will clean the fuse ends and fuse clips up quite nicely...More later,
Tour...
Vox Copuli
Better to remain silent and be thought a fool, than to open your mouth and remove all doubt. - Old English Proverb
"Death doesn't come with a Uhaul." - Dennis Gardner
"It's easy to get lost in price vs performance vs ego vs illusion." - doro
"There is a certain entertainment value in ripping the occaisonal (sic) buttmunch..." - TroyD