Speaker Gaskets - The best to use in 2025

Hi Guys,
I did some searching and alot comes up about gaskets, paper, Mortite, use of weatherstripping, various posts of people using other things.
Didnt seem to be a clear winner.

I have two pair of my 1988 built Monitor 11Ts apart to get the crossovers to Trey and I'd like to put in all fresh gaskets when I put them back together.
(I also just ordered hurricane nuts and bolts for them).

Personally my gut says I think I'd like to just put in all new factory gaskets if they are available, they did an amazing job for 37 years from 1988 until now.

What say you is the best option "Now".

Thanks
Jimmy P

Welcome!

It looks like you're new here. Sign in or register to get started.

Comments

  • Posts: 51,031
    edited March 8
    The clear winner is the original gaskets. Unless they are torn/damaged do not replace. They are supposed to be paper thin.

    If one or more need replacement due to damage the gasket stuff at Parts Express is good enough. There are no factory gaskets available.

    Under no circumstance should you use Mortite.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."


    President of Club Polk

  • Posts: 25,990
    edited March 8
    Armaflex tape works as well. You will need to cut it to fit. Whether you use armaflex or the PE gasket stuff remember to cut on the diagonal were ends meet or you'll have an air leak.
    A soldering iron works good to burn screw hols where needed. IME just pushing the screw through material can cause it to grab the material and twist it up sometimes.
  • Posts: 25,554
    edited March 8
    The compressibility of this material is on par with the original gasket material and has been teh preferred solution for more than a decade to replace the OE gaskets if needed. t1b9m1mhrdqp.jpg
    The Gear... Carver "Statement" Mono-blocks, Mcintosh C2300 Arcam AVR20, Oppo UDP-203 4K Blu-ray player, Sony XBR70x850B 4k, Polk Audio Legend L800 with height modules, L400 Center Channel Polk audio AB800 "in-wall" surrounds. Marantz MM7025 stereo amp. Simaudio Moon 680d DSD

    “When once a Republic is corrupted, there is no possibility of remedying any of the growing evils but by removing the corruption and restoring its lost principles; every other correction is either useless or a new evil.”— Thomas Jefferson
  • Posts: 17,466
    Armaflex works great, my 2.3tl’s are the first build I did, and just used the original gaskets..
  • Posts: 33
    edited March 9
    Thanks Guys.
    So my gut as a car guy was to replace all gaskets, but if you guys say if they are not torn leave it.
    I dont think any of mine were damaged on removal was I'll just put the stockers right back in.

    Very good intel on burning a hole vs just pushing the screw through if I had to make new gaskets.

    Thanks for the continuing education (and enabling LOL).
  • Posts: 1,408
    ^ Was in the same way of thinking after acquiring my sda srs speakers, thought the gaskets should be replaced or upgraded.
    f1, in his subtle way, convinced me to stay with the thin originals.
    They seal up great, stay with them if not damaged.

Welcome!

It looks like you're new here. Sign in or register to get started.

Welcome!

It looks like you're new here. Sign in or register to get started.