Tweeters
polklover656
Posts: 25
I’m trying to remove my tweeters from my monitor 10a speaker, but the wires are soldered to the tweeter how would I remove it?
Best Answer
-
I didn't risk it with mine. I cut the wire to a 1" length and crimped and backflow soldered on some 7/64" (0.109") male fastons. Actually, I made them myself from 4N copper and copper crimp sleeves.
If you attempt de-soldering, you'd better have some good clip on aluminum heatsink clamps on the terminals and work quickly.George / NJ
Polk 7B main speakers, std. mods+ (1979, orig owner)
Martin Logan Dynamo sub w/6ft 14awg Power Cord
Onkyo A-8017 integrated
Logitech Squeezebox Touch Streamer w/EDO applet
iFi nano iDSD DAC
iPurifier3
iDefender w/ iPower PS
Custom Steve Wilson 1m UPOCC Interconnect
iFi Mercury 0.5m OFHC continuous cast copper USB cable
Custom Ribbon Speaker Cables, 5ft long, 4N Copper, 14awg, ultra low inductance
Custom Vibration Isolation Speaker Stands and Sub Platform
Answers
-
Desolder the connection.Political Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."
President of Club Polk -
Will the heat damage the tweeter? That may be a problem, I have not experience with soldering...
-
If you don't know what doing, don't do it.Political Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."
President of Club Polk -
Amazing idea gardenstater, Smart outside the box
that’s what I’ll do
