Help. Need to know how to setup my polk audio rtia9 speakers with my receiver
ripdive
Posts: 2
I recently bought a sony str dn1040. Will this receiver work for the rtia9? How do you set it up?
Comments
-
It will work, yes, but that's way too weak of an AVR for those speakers. 22 pounds, 100 watts with two channels @ 6 ohm so 8 ohm rating is even less.
Don't crank it. Ever.
Red speaker post to red speaker terminal, black to black, L to R with speaker wire. Source (whatever you're hooking up) to input on the AVR with a pair of RCA interconnects.afterburnt wrote: »They didn't speak a word of English, they were from South Carolina.
Village Idiot of Club Polk -
It will work, yes, but that's way too weak of an AVR for those speakers. 22 pounds, 100 watts with two channels @ 6 ohm so 8 ohm rating is even less.
Don't crank it. Ever.
Red speaker post to red speaker terminal, black to black, L to R with speaker wire. Source (whatever you're hooking up) to input on the AVR with a pair of RCA interconnects.
Thanks. What do you recommend to increase power? -
There isn’t anything you can do with that AVR to increase power. You would need to replace it with a different that has pre outs.
-
I recently bought a sony str dn1040. Will this receiver work for the rtia9? How do you set it up?
No!Political Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."
President of Club Polk
