Thinking about my Monitor 7’s
JayMX
Posts: 446
So I own two pair of Monitor 7's. A bone-stock, near perfect pair of 7b's with Peerless, and my fully modded 7c’s (194's, Dynamat, H-nuts, Sonicaps, Mills, ash veneer). Thinking I might swap my modded x-overs into the 7b's just for kicks. Trying to decide if I should redo the b's x-overs... they feel dull and lifeless to me when compared to the c's.
The only difference I can see in the schematics of the b x-over vs the c x-over is 0.01mH in the tweeter inductor (b schematic shows 0.23mH and c schematic shows 0.22mH). Should be Imperceptible, no? Is this a bad idea? I’m thinking it might just be a direct swap-and-go to compare... Thoughts?
The only difference I can see in the schematics of the b x-over vs the c x-over is 0.01mH in the tweeter inductor (b schematic shows 0.23mH and c schematic shows 0.22mH). Should be Imperceptible, no? Is this a bad idea? I’m thinking it might just be a direct swap-and-go to compare... Thoughts?
Current Collection: Monitor 4a (Peerless), Monitor 5B (Peerless), Modified Monitor 7b (Peerless), RTA15TL (SL3000), SDA CRS+ (194’s), SDA SRS 2.3TL, R100's, R200’s, R300 🤩
Comments
-
Double check the resistors values on the actual crossovers, not the schematics.Home Theater/2 Channel:
Front: SDA-2ATL forum.polkaudio.com/discussion/143984/my-2as-finally-finished-almost/p1
Center: Custom Built forum.polkaudio.com/discussion/150760/my-center-channel-project/p1
Surrounds & Rears: Custom Built forum.polkaudio.com/discussion/151647/my-surround-project/p1
Sonicaps, Mills, RDO-194s-198s, Dynamat, Hurricane Nuts, Blackhole5
Pioneer Elite VSX-72TXV, Carver PM-600, SVS PB2-Plus Subwoofer
dhsspeakerservice.com/
