PSW202 is "chirping" during scenes with loud bass.

jaugustm
jaugustm Posts: 1
in Troubleshooting
I recently bought this Polk Audio PSW202 new, and immediately noticed a "chirping" or "squeaking." It only has happened during movies and during 'booming' scenes. Music has been fine so far. All screws are tight.
· Share on FacebookShare on Twitter

Comments

  • VR3
    VR3 Posts: 28,741
    Sounds like it is clipping and or bottoming out
    - Not Tom ::::::: Any system can play Diana Krall. Only the best can play Limp Bizkit.
    · Share on FacebookShare on Twitter
  • F1nut
    F1nut Posts: 50,647
    VR3 wrote: »
    Sounds like it is clipping and or bottoming out

    Agreed. Turn the volume level of the sub down.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter
  • txcoastal1
    txcoastal1 Posts: 13,302
    F1nut wrote: »
    VR3 wrote: »
    Sounds like it is clipping and or bottoming out

    Agreed. Turn the volume level of the sub down.

    Yeah, you're scaring the birds
    2-channel: Modwright KWI-200 Integrated, Dynaudio C1-II Signatures
    Desktop rig: LSi7, Polk 110sub, Dayens Ampino amp, W4S DAC/pre, Sonos, JRiver
    Gear on standby: Melody 101 tube pre, Unison Research Simply Italy Integrated
    Gone to new homes: (Matt Polk's)Threshold Stasis SA12e monoblocks, Pass XA30.5 amp, Usher MD2 speakers, Dynaudio C4 platinum speakers, Modwright LS100 (voltz), Simaudio 780D DAC

    erat interfectorem cesar et **** dictatorem dicere a
    · Share on FacebookShare on Twitter