Sda srs 2.3 crossover question. Polyswitch.
bassfann
Posts: 151
Just double checking. S1 is the location of the tweeter poly switch,correct ? I removed the PR and found the crossover dangling,held up by wire ties and electrical tape,I'm assuming (and praying),that this is not from the factory.
Comments
-
S1 is the location. The crossovers are normally attached to the large spool inductor with snap-in nylon standoffs.Home Theater/2 Channel:
Front: SDA-2ATL forum.polkaudio.com/discussion/143984/my-2as-finally-finished-almost/p1
Center: Custom Built forum.polkaudio.com/discussion/150760/my-center-channel-project/p1
Surrounds & Rears: Custom Built forum.polkaudio.com/discussion/151647/my-surround-project/p1
Sonicaps, Mills, RDO-194s-198s, Dynamat, Hurricane Nuts, Blackhole5
Pioneer Elite VSX-72TXV, Carver PM-600, SVS PB2-Plus Subwoofer
dhsspeakerservice.com/ -
I know about the standoffs.I wonder why previous owner just hung them there,very sad. I soldered the joints together on the reverse side of the board to eliminate the switches.
