mw6517 ???
cooley53
Posts: 26
I found the specs on these drivers via this forum but can't seem to find out if they were used in any speaker other than the rms1000w bass module they were pulled from. Just wondered if they are a viable replacement for any of the other 65xx drivers. Sorry about the pic being so BIG. 
Best Answer
-
Doubtful. The have a relatively high Fs, and low Vas.Home Theater/2 Channel:
Front: SDA-2ATL forum.polkaudio.com/discussion/143984/my-2as-finally-finished-almost/p1
Center: Custom Built forum.polkaudio.com/discussion/150760/my-center-channel-project/p1
Surrounds & Rears: Custom Built forum.polkaudio.com/discussion/151647/my-surround-project/p1
Sonicaps, Mills, RDO-194s-198s, Dynamat, Hurricane Nuts, Blackhole5
Pioneer Elite VSX-72TXV, Carver PM-600, SVS PB2-Plus Subwoofer
dhsspeakerservice.com/
Answers
-
westmassguy wrote: »Doubtful. The have a relatively high Fs, and low Vas.
Thanks. Not sure what that means but I will take your word for it. So I take it they were made for "bass modules" only. Will put it up for sale or use it as it was intended.