OEM CRS stands
elitt
Posts: 162
I'm looking for any year/any dimensions produced and will pay whatever is considered fair or fair+ these days. I know it's a longshot! NYC tri-state area. Thanks all!
Comments
-
You'd be better off having the stand fabricated. Plenty of metal-workers and blacksmiths in the tri-state area.
Home Theater/2 Channel:
Front: SDA-2ATL forum.polkaudio.com/discussion/143984/my-2as-finally-finished-almost/p1
Center: Custom Built forum.polkaudio.com/discussion/150760/my-center-channel-project/p1
Surrounds & Rears: Custom Built forum.polkaudio.com/discussion/151647/my-surround-project/p1
Sonicaps, Mills, RDO-194s-198s, Dynamat, Hurricane Nuts, Blackhole5
Pioneer Elite VSX-72TXV, Carver PM-600, SVS PB2-Plus Subwoofer
dhsspeakerservice.com/ -
Hey, I appreciate that. I have the plans saved and may go that route. I'm a bit of a stickler for oem, but if there were drawbacks in the original I'm all for fabrication.
Does anyone have advice about that particular decision?
I finally got the CRSs at the right level and man, what a difference. I can imagine it only gets better with the isolation of the original stands. -
If it were me, I'd probably go with 2" steel, and make provisions to fill all the tubes with lead shot. Get some nice 1 1/2" spikes, and have the fabricator tack the inserts.Home Theater/2 Channel:
Front: SDA-2ATL forum.polkaudio.com/discussion/143984/my-2as-finally-finished-almost/p1
Center: Custom Built forum.polkaudio.com/discussion/150760/my-center-channel-project/p1
Surrounds & Rears: Custom Built forum.polkaudio.com/discussion/151647/my-surround-project/p1
Sonicaps, Mills, RDO-194s-198s, Dynamat, Hurricane Nuts, Blackhole5
Pioneer Elite VSX-72TXV, Carver PM-600, SVS PB2-Plus Subwoofer
dhsspeakerservice.com/
