Crossover Plate Question

boston1450

My spare 2b's havent been used in awhile & last time i moved them to store i noticed something loose. I opened it up & behold the crossover plate (if thats what its called) came undone. I tried to figure how it goes. So i opened up the other speaker & tried to position it the same & it didnt seem to work. The plastic pins didnt seem to line up. Then i played around with it & it fit at a angle. I want to make sure its right before i mount it back in place. I will post picture. Thanks

boston1450

The good one

boston1450

The angled one

boston1450

^^^^^ this one came totally off & appears to be seated right. I think. Maybe the base turned ???????

boston1450

Dumb A$$ i am. Yes it turned & i positioned it back. Sorry for the screw up. Is it ok to just use power grab & mount it back

boston1450

While in there i glued magnets & stapled fill back up as it slid down quite a ways on one & did the other to prevent it. Fun project

westmassguy

The crossover board is mounted to the spool inductor with 4 nylon standoffs. The spool inductor will spin if the hex-head cap screw is loose. Get your Allen wrenches, square up the crossover, and tighten the cap screw from the rear side of the speaker.
DO NOT GLUE THE SPOOL INDUCTOR!

boston1450

You are correct. I screwed it back snug from rear outside & held base. It was loose. I tightened both up. Waiting for drivers to be put back in place. Looks good otherwise

PolkieMan

Hey those look stock have you changed anything?

boston1450

No i havent. Bone stock