just got a Yamaha RX-A1040 and Monitor 60 and 70

2»

Comments

  • afterburnt
    afterburnt Posts: 7,892
    The YAPO set it all the way down to 40 with the new amp
    · Share on FacebookShare on Twitter
  • afterburnt
    afterburnt Posts: 7,892
    So far so good with the XPA-200, I think I want an XPA-5 now!
    · Share on FacebookShare on Twitter
  • Polkie2009
    Polkie2009 Posts: 3,834
    edited December 2014
    My YAPO had all kinds of crazy settings after I ran it on my Yamaha 663, sounded better after I adjusted the front and center speakers to small. At least YAPO had the side and back surrounds set to small. I also had to adjust the avr's crossover down from 120hz. to 80hz. If you are using the AVR's crossover setting, make sure the crossover ON THE SUBWOOFER is set to max. Let the sub's amp handle the bass load, the weak power supply in the avr will appreciate it. Always recheck the distances from main listening position and each speaker, YAPO can and has been known to be off. If you can get your hands on a db meter to check each speaker level (I usually use 75 dbs. but others may go for more). I know it's a lot to take in , but if in doubt, RTFM,lol. I had to go back to mine a number of times. Good luck with the Emo.
    · Share on FacebookShare on Twitter
  • F1nut
    F1nut Posts: 50,734
    afterburnt wrote: »
    So far so good with the XPA-200, I think I want an XPA-5 now!

    Congrats, you are their target customer.

    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter
  • afterburnt
    afterburnt Posts: 7,892
    Dutch hater
    · Share on FacebookShare on Twitter
  • afterburnt
    afterburnt Posts: 7,892
    XPA-3 on the way!
    · Share on FacebookShare on Twitter