Crossover Location

gkellerman
gkellerman Posts: 8
edited January 2004 in Troubleshooting
OK, I've gotten replacement Crossovers for my SDA 2B's. Before I rip anything and everything apart looking for them could someone please tell me the location so I have to do minimal disassembly?

Thanks
gkellerman@niche-soft.com
Post edited by gkellerman on
· Share on FacebookShare on Twitter

Comments

  • F1nut
    F1nut Posts: 50,564
    edited January 2004
    Take out the binding post plate (4 screws) on the back of the speaker cabinet, it should be attached to it. Or, you can take out the PR to gain access from the front.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter
  • gkellerman
    gkellerman Posts: 8
    edited January 2004
    I done took those screws out but there are some wires attached to it that are somewhat taunt. There is an Allen Screw head about 6" above that plate. Is it possible the crossover is attached to that?
    gkellerman@niche-soft.com
    · Share on FacebookShare on Twitter
  • F1nut
    F1nut Posts: 50,564
    edited January 2004
    Yes, that's it. I couldn't remember exactly were it was, but knew it was right near the plate. It'll be easier to gain access by going through the front.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter
  • gkellerman
    gkellerman Posts: 8
    edited January 2004
    Thanks Nut. Looks like I'll wait until morning to go scrounging around in the garage for the Allen wrench set.
    gkellerman@niche-soft.com
    · Share on FacebookShare on Twitter