KIMBER kABLE TERMINATION
gwh
Posts: 1,451
i'VE BOUGHT SOME UNTERMINATED KIMBER KABLE (4VS) OFF EBAY AND WOULD LIKE TO KNOW IF I SHOULD USE SPADES OR PLUGS ON THE ENDS. I HAVE A DENNON RECEIVER AND WILL BE RUNNING THE CABLE TO RTI38'S AND BI-WIRING A CSI40.
AS FOR QUALITY, WOULD A GOLD PLATED CONNECTOR FROM RADIOSHACK WORK OR SHOULD I LOOK ELSEWHERE?
THANKS FOR YOUR TIME!
AS FOR QUALITY, WOULD A GOLD PLATED CONNECTOR FROM RADIOSHACK WORK OR SHOULD I LOOK ELSEWHERE?
THANKS FOR YOUR TIME!
HT:
Martin Logan Motion 40
Martin Logan Motion 50XT
Emotiva Airmotiv E2
SVS SB16 Ultra
Def Tech Reference Sub
Yamaha RX-A3070
Signal Cable speaker wires & interconnects.
Martin Logan Motion 40
Martin Logan Motion 50XT
Emotiva Airmotiv E2
SVS SB16 Ultra
Def Tech Reference Sub
Yamaha RX-A3070
Signal Cable speaker wires & interconnects.
Post edited by gwh on
Comments
-
Either choice will work for the ends, but make sure your Denon and speakers will accept them.
Please don't use caps, it's rude.Political Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."
President of Club Polk -
Denon receivers don't except spades,use banana ends for best results.Kimbers ends are very nice and well built.Dan
My personal quest is to save to world of bad audio, one thread at a time.