Soundbar 6000 Automatically Changing Source or Going Off

ewrankin
ewrankin Posts: 1
edited February 2013 in Troubleshooting
I have been dealing with a frustrating problem since I got the Soundbar. Whether using the remote from the unit or the TV remote that is programmed. When doing simple volume changes the Soundbar will automatically change from Source 1 to Source2 or sometimes it just goes off.

It's so bad that my wife want's me to get rid of it. Looking for solutions...any help is appreciated.
Post edited by ewrankin on
· Share on FacebookShare on Twitter

Comments

  • DracoAmericanus
    DracoAmericanus Posts: 112
    edited February 2013
    on other products that i have seen this problem on, was usually caused by the source volume being too low. on an speaker with it's own amp, they sometimes wont correctly detect an input if the level is to low from the tv. i.e , the customer has the TV's volume a bit too low( or not using a fixed output when equipped ) and only uses the speakers volume to compensate.
    There is no cure....
    Luxman M117, SDA SRS 2.3, rear monitor 10, back rear bose 4.2, valodyne sub and 2 Onkyo m-504 amps Onkyo TX-NR709
    8mm, 7.62x39mm
    · Share on FacebookShare on Twitter
  • DracoAmericanus
    DracoAmericanus Posts: 112
    edited February 2013
    Did my suggestions help or hinder?
    There is no cure....
    Luxman M117, SDA SRS 2.3, rear monitor 10, back rear bose 4.2, valodyne sub and 2 Onkyo m-504 amps Onkyo TX-NR709
    8mm, 7.62x39mm
    · Share on FacebookShare on Twitter