RTS100 Speakers - Blown Mothe Boards

Spartan_Gene
Spartan_Gene Posts: 1
edited February 2013 in Troubleshooting
Hello,

Does anyone know if I can find replacement mother boards for my speakers. They are the ones that are connected to my tweeters in my rts-1ooo speakers.

photo(1).jpg
photo2.jpg


photo(1).jpg
Post edited by Spartan_Gene on
· Share on FacebookShare on Twitter

Comments

  • F1nut
    F1nut Posts: 50,546
    edited February 2013
    Just replace the damaged parts.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter
  • drumminman
    drumminman Posts: 3,396
    edited February 2013
    Yep, boards don't look damaged. It would help to have pics of the other side, too.
    "Science is suppose to explain observations not dismiss them as impossible" - Norm on AA; 2.3TL's w/sonicaps/mills/jantzen inductors, Gimpod's boards, Lg Solen SDA inductors, RD-0198's, MW's dynamatted, Armaflex speaker gaskets, H-nuts, brass spikes, Cardas CCGR BP's, upgraded IC Cable, Black Hole Damping Sheet strips, interior of cabinets sealed with Loctite Power Grab, AI-1 interface with 1000VA A-L transformer
    · Share on FacebookShare on Twitter
  • Anthony Hinton
    Anthony Hinton Posts: 107
    edited February 2013
    Can you solder?
    · Share on FacebookShare on Twitter
  • Lordbrega
    Lordbrega Posts: 1
    edited February 2013
    I don't know why I didn't take a picture of the other side. There's a part that's fried. I'll take on tonight.
    · Share on FacebookShare on Twitter
  • ken brydson
    ken brydson Posts: 8,759
    edited February 2013
    Lordbrega wrote: »
    I don't know why I didn't take a picture of the other side. There's a part that's fried. I'll take on tonight.

    Why the new user name?

    Wait, the OP was the new one....
    · Share on FacebookShare on Twitter