DSW PRO 600 Burnt part

meanuc
meanuc Posts: 7
edited December 2012 in Troubleshooting
I have a burnt part labeled as C7 on a circuit board where the main power ties into the sub. I believe it is some sort of diode. Does anyone know what this is and where I can get one?
Thanks
Post edited by meanuc on
· Share on FacebookShare on Twitter

Comments

  • F1nut
    F1nut Posts: 50,549
    edited December 2012
    Give Polk a CALL on Monday. They won't sell you the part, but you can send it in to them for repair. Depending on what's what, they may even fix it under warranty.

    Oh yeah, C would indicate a cap.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter
  • ambiophonics
    ambiophonics Posts: 726
    edited December 2012
    I would contact polk or take it to a local service center. It's unlikely that the burned part was the only point of failure.
    2 Channel - Polk SDA-2BTL, Carver TFM-35, Peachtree iDAC, Qobuz streamed via Episode Lynk using bubble UPnP server
    · Share on FacebookShare on Twitter