SDA interconnects

nolasally
nolasally Posts: 4
edited May 2012 in Wanted (WTB) Classifieds
Also in need of female connectors that are in the backside of 2b's! Please help newbie. I am also an AKer!
Post edited by nolasally on
· Share on FacebookShare on Twitter

Comments

  • Toolfan66
    Toolfan66 Posts: 17,329
    edited May 2012
    Please don't listen to that garbage above!!

    Buy a set of good binding post (one set) add one to each binding post cup and just by pass the pin blade outlet (leave the original outlet in there) then you can make your own interconnect cable with your favorite speaker wire using bananas on each end.

    You can also make your own AI-1 dreadnought, this way you can use non-common ground amps if you choose..


    Just my .02
    Polk Audio SDA 2.3tl Fully Hot Rodded. 😎

    SVS SB16 X2

    Cary SLP-05/Ultimate Upgrade.
    Cary SA-500.1 ES Amps
    Cary DMS 800PV Network
    OPPO UDP 205/ModWright Modification
    VPI Scout TT / Dynavector 20x2
    Jolida JD9 Fully Modified

    VPI MW-1 Cyclone RCM

    MIT Shotgun 3 cables throughout / Except TT, and PC’s
    · Share on FacebookShare on Twitter
  • pitdogg2
    pitdogg2 Posts: 25,659
    edited May 2012
    Toolfan66 wrote: »
    Please don't listen to that garbage above!!

    Buy a set of good binding post (one set) add one to each binding post cup and just by pass the pin blade outlet (leave the original outlet in there) then you can make your own interconnect cable with your favorite speaker wire using bananas on each end.

    You can also make your own AI-1 dreadnought, this way you can use non-common ground amps if you choose..


    Just my .02



    Listen to this guy... It's the right route
    · Share on FacebookShare on Twitter