Soundbar 4000-subwoofer not working, HELP!

rachael
rachael Posts: 1
edited February 2012 in Troubleshooting
Just got the Soundbar 4000 by Pol and get no sound from the woofer. It powers on but no sound. The light is slow blinking green, not a solid green. Any thoughts? Any advice would be greatly appreciated. Thank you!
Post edited by rachael on
· Share on FacebookShare on Twitter

Comments

  • kawizx9r
    kawizx9r Posts: 5,150
    edited February 2012
    Make sure the subwoofer is set to the same channel as the surround bar.

    There is a small switch that goes from 1-4 behind both the subwoofer and surround bar. You have 4 frequencies to choose from for them to operate without interfering with other wireless objects IE wireless router, etc.
    Truck setup
    Alpine 9856
    Phoenix Gold RSD65CS

    For Sale
    Polk SR6500
    Polk SR5250
    Polk SR104


    heiney9 wrote: »
    Any clue how to use the internet? Found it in about 10 sec.
    · Share on FacebookShare on Twitter
  • Serendipity
    Serendipity Posts: 6,975
    edited February 2012
    If blinking Green it is looking for a signal, if Red it's in protect mode. Make sure you have the sub set up properly and on the same frequency, as indicated above.
    polkaudio RT35 Bookshelves
    polkaudio 255c-RT Inwalls
    polkaudio DSWPro550WI
    polkaudio XRT12 XM Tuner
    polkaudio RM6750 5.1

    Front projection, 2 channel, car audio... life is good!
    · Share on FacebookShare on Twitter